answersLogoWhite

0

You can get help with the configuration of a router at your local computer store or on the internet. Your router's manufacturer will most likely have a webpage, dedicated to a router setup tutorial. If you still feel unsure about how to do this you can always check out YouTube for a video tutorial. Last but not least, you can post any problems on a PC Hardware forum. Most people will be glad to help you out there.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What is the purpose of NV RAM on a Cisco router?

That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.


What is global router configuration?

I'll go to hellis Cisco in a Cisco router. What would the prompt look like for global configuration


Where does the router running configuration reside?

The router's running configuration resides in its volatile memory (RAM). This configuration is the active set of settings that the router uses to operate and can be modified dynamically. However, it is lost when the router is powered down or restarted, unless it is saved to the non-volatile memory (NVRAM) as the startup configuration.


State four typical router configuration file items?

State four typical router configuration file items?


What configuration of a router would be restored to the device after the reload?

The System Configuration Dialog of a router would be restored to the device after the reload.


What is reset botton in router?

The reset button in a router let you remove all the configuration you do and gives you the default configuration from factory.


What is the purpose of the startup configuration file on a Cisco router?

The startup configuration file on a Cisco router contains the configuration settings that are loaded into the router's memory when it boots up. It specifies parameters such as interface settings, routing protocols, access control lists, and other operational settings required for the router to function properly. This file is stored in the router's non-volatile memory (NVRAM), ensuring that the configuration persists even when the router is powered off. Essentially, it serves as the baseline configuration that the router uses to establish its operational state.


Which router component stores the start up configuration file?

NVRAM is that router component in which start up configuration file is stored.


What tcp ip configuration specifies the address of a router?

The "default gateway" is your router.


On a router which actions can be performed in user mode?

view current router configuration


How do you get one router to use the signal of another?

You should use so called "Bridge" configuration.


Can you configure multiple as on single router using eigrp?

Yes; a router might be a border router between two areas of a network - for example, one configured for AS 100, one for AS 200. However, unless you do some additional configuration, no information will automatically be shared between the two areas. The configuration is related to "route redistribution".