0
Where can you buy new front brake rotors for a 1987 Chevy half ton 4WD Pick up?
Wiki User
∙ 16y ago
Advanced Auto or Auto Zone usually carries them! O' Reillys is new but they might have them!
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you remove the front brake rotors and hubs on a 1987 Toyota 4WD Pickup?
Get a shop manual for about $18 and it has pictures and everything.
How do you change front brake rotors on a 1987 toyota 4x4?
Changing brake rotors is pretty easy. One lifts the car, removes the tired, brake shoe and then the brake rotor. Next replace the brake rotor, put the brake shoe and tire back on the car and lower it back to the ground.
How do you change the rotors on a 1987 Mazda 323?
The front rotors need to be pressed on, if you know someone with an industrial press you can do it yourself.
Is a 1987 Chevy Celebrity a front wheel drive?
Yes
Where can you get an exploded view of rear brake assembly for 1987 Chevy?
You can get and exploded view of the 1987 Chevrolet rear brake assembly and most Chevrolet dealerships. Most local libraries will have service manuals with the exploded rear brake assembly view.
Where in a 1987 Chevy Celebrity do you put brake fluid?
Master cylinder. Mounted on the firewall, driver's side.
View of brake caliper assembly on a 1987 Mazda pickup?
How to Install Front Brake Pads Check Related links below.
Will a 1987 Chevy Monte Carlo SS front clip fit on a 1989 Chevy caprice?
Not without major modifications.
Is the front drive shaft of a 1987 Chevy v10 spring loaded?
NO. It has a slip yoke.
Is one or both front wheel bearings going when you are only moving forward at any speed in your 1987 Dodge Colt and you hear a low volume pulsing noise from the front of the car?
low pulsating noise makes it sound more like warped brake rotors. if you feel any pulsating on the brake peddle when slowing down, it's quite likely the rotors need to be replaced. bearing failure sounds usually increase in pitch and can sound like a drone or a howl depending on your speed and bearing condition, rather than a pulsating.
On a 1987 Honda Accord why would the brake pedal vibrate when you press the it at 35 mph if you have replaced the rotors three times and it did not help?
AnswerUsually a pulsating brake pedal is an indication of a warped rotor. When you replaced the rotors did you torque the lug nuts to the proper specs, (80 ft lbs)? If not then you are warping them each time. Also make sure you tighten in a criss cross pattern. Of course you need to check each and every rotor for trueness. Also a warped wheel can cause this. Check all your wheels for a bent condition.If your brake pedal is pulsating. You might have a out of round rear brake drum. When your front rotors are warped you will feel it in your steering wheel. Try this test. lightly rest your foot on the brake pedal, with your foot resting on the pedal slowly apply your E brake. ( your E brake only works your rear brakes) If your brake pedal pulsates the problem is in the rear brakes.
Where is the fuse box on an 1987 Isuzu pup?
under the hood on the driver side in front of the brake booster
