an "AIR INTAKE" is only a tube which redirects the air filter location. to make your own "intake" you can follow the throttle body, (which where the air filter will follow) remove all of the inlet tube, air box and filter. you can customize a tube that will come from the throttle body, and route to a lower place than the old air filter allowing colder air to be vaccummed into the tb. This will cause a high a/f ratio allowing more hp to be allowed. DO NOT WASTE $200 on an aftermarket TUBE. its only an extended air filter. THATS ITAnswerif its a 1993 or so it sould be on the driver side and goes from the headlight and up to the windshield area of the engine. or i you are looking for a whole one try a junkyard or a "pick-and-pull" type place, or an import car parts store. Answergo to www.protegegarage.com
No, you'll need an intake hose for either a 97 or 98
How you replace the cabin filter mazda protege 5 2003
It's located between the battery and the air intake. The top is black rubber not yellow.
It is a small square box near the beginning of your air intake. It has two Phillips screws in it and wires coming out of it
On my 1997 Protege a hose runs from the valve cover to the air intake assembly. Where the hose connects to the valve cover is the PCV valve.
How to know if air sensor not working on protege 2003
an air leak in your intake will cause the engine to rattle. Protege's intake hoses are prone to cracking.
check your mass air flow sensor and your air filter. the MAS is located near your filter and it is in the pipe that goes to the intake
it looks like they sell the, at www.1aauto.com i hope this helps - j.b they only have the 95 and 96 model
i have that problem! i have not figured out what it is but im thinking it is my air temperature sensor i have a 2002 protege lx it has a aftermarket muffler and a cold air intake i have replaced the spark plugs, wires changed all the fluids had it tested and have had no luck if i do i will post the answer but if you find a answer can u maybe email me the answer? my email is email@example.com
Follow the plug wires back to the distributor cap. On my 93 DX it is on the drivers side of the engine block underneath the air intake assembly.
BECAUSE ITS DOING ITS JOB!!!!!!!!!!!!!.whats your next question. why does my Mazda have doors?
what is the tork for the intake(bolt 8mm) v6 3l 2001 Mazda tribute es
what is your ?, a MAF is basicly a IAT The Mazda Protege and Protege 5 2.0L engine has an IAT Sensor located just past the factory air filter box. It is a two wire sensor that plugs into the intake tube via a rubber grommet. The three wire plug in the Mass Air Flow Sensor. DO NOT Unplug either of these sensors while the vehicle is running or key turned to accessory. Will cause a flag in the computer and turn on the Check Engine Light. Hope this helps.
Replace the PCV Valve.
On air box right befor maf sensor
Need to know what its doing or not doing so that I can better assist you.............
A 95 Mazda Protege will shut off during acceleration if the air and fuel mixture is drastically incorrect. A vacuum leak or fuel flow restrictions can both cause this problem.
There are a few reasons why a 1994 Mazda Protege won't start, but does crank. A couple of reasons could be the air flow sensor or a problem in the fuel lines.
Its called breather hose. It will cost you less than $ 10.00.
The intake air temperature sensor is located on the mass air flow sensor on the intake. There are five wires attached to the sensor.
Connects air filter and engine.
In mass air flow sensor.
The fuel filter is on the fire wall under where your brake drum sits. it has a bent outlet valve on top of it. you will have to take your fresh air hose off from the injectors and the air intake control unit. that will make your life easier.
The 2001 Mazda Prot?g? air conditioning fuse can be found in the fuse box. The air conditioning fuse will be in the first column, third from the bottom.