usually your local boneyard can help you. they usually have a bunch of different years and models. with your part the same piece is in berettas and some corsicas from the years of 91-96, so any of those should match. jeremy aka ccz5105
Can I attach a piece Velcro to the back of a cell phone (plastic?) with Elmer's glue?
hello what is or where does small round plastic piece inside float bowl on 350 honda 4wheeler go?
It's a hard plastic... so it look like a block of plastic. Almost like a thick piece of glass.
The mass of the piece of plastic = density × volume = 1.18 g/cm3 × 50.0 cm3 = 59 g = 0.059 kg.
Filter!
If the shift knob on a 1995 Chevy Beretta broke off from the metal bar, the metal bar is called the shift lever. The shift lever might be available at a reduced price from an automobile salvage yard.
is located under the ashtray behind the shifter ,remove piece of plastic and the obd ll connector is there
Italy ... BTW a Beretta is a fine piece.
on the Chevy beretta there are 2 flashers one is right next to the steering column to the behind the plastic dash piece,this is your turn signal flasher replace it and your signals should work.
The part is called the Gearshift Selector Bushing.
No. just remove the plastic piece around the radio. It pops off.
The center panel can just pop out, pop it out and then you will see the clips on the right side of the shifter, unclip the plastic piece and the bulb is right under that.
The Chevy heater hose removal tool is a plastic piece that clamps around the hose. The tool slides into the fitting to release the hose.
Gently pry the black plastic rectangular piece from around the shifter. Unplug the lighter assembly. The chrome plastic piece needs to be removed by prying the 4 clip locations. The green bulb will now be visible and can be pulled out by using a pliers with light pressure. Insert the new bulb the same way. The job is easier than you might think. Bulb # 168G. Package of 2 from Autozone for $4.00.
Try this website saveatus21.com
behind a removeable plastic trim piece in the left rear of the vehicle - this plastic is about 30" long and supports the retractable cargo cover open the rear hatch/tailgate and work from the rear release two plastic clips - one forward and one rear wiggle the plastic piece out and the jack is behind it
you will have to take the console out or at least the top piece of the console and then you will see the shifter is bolted to the floor.