It is available on ebay. $14.95 + $3.95 S&H. A true bargain for what it does.
take it to a garage take it to a garage more than likely its your ABS module. def. find someone to run a diagnostic on it first before you get a new module. Dont buy a new or reused module either. take you old module out and have it rebuilt. you can get the module rebuilt for 100-200 dollars. a used module will go out on you very soon and a new module will cost at least 1000 bucks. if its not the module, check your abs sensor and your brake sensors from your brake pads. i had the same problem and my abs module was dead and i also had a short in my wear sensor for my brakes.
It's located in your car. Take it to a professional. If you can't even find the part (actually you don't even know the correct name for it), you definitely shouldn't be touching it.
You can find a Steeler's brake light hitch at most auto part stores. You can also find it at various junk yards.
If I understand your post: The brake light is on constantly? If so, you may want to adjust or replace the brake light switch located at the top of the brake pedal.
You can find the 2007 Nissan brake light fuse in the fuse box. The brake light fuse will be in the second column, third from the top.
why or how do i find the brake light switch on my 1997 nissan 200sx. how do i chane it out.
Somewhere rear brake light area.
Put this question into google, and you will find many reasons and remedies to this problem. Ei...brake light switch, brake light bulbs, including the upper brake light bulbs.
you can find the switch on the back of the brake pedal.
Generally the brake light switch it under the dash, Follow the brake pedal arm up under the dash you should find it there. Hope This Helps.
well my abs light was on cause i needed brake fluid..... If you do need to read the ABS codes, the module is under the panel next to the rear passenger seat. This is an OBDI car not an OBDII car.
To change the brake light bulb on a 1999 Honda Passport find the light housing located in the trunk. Find the plastic covers for the lights and remove them. Pull the bulbs out carefully and replace them.