you can buy a Chilton book or a Haynes book for the year of your car at any auto parts store.
I have a 1998 Legacy Outback LTD and have replace the fob sucessfully with one purchased on e-bay. Programming instuctions are available as well.
CJ GLS was created on 1998-03-02.
4 x 100
There are several good discussion forums sites that are likely to have portions of the Legacy wiring diagrams posted or which can provide answers to specific questions:* LegacyGT.com* bbs.legacycentral.org (covers 89-94 model years)* ScoobyMods.comLocal Subaru dealers are pretty good about letting you take a look at Subaru's wiring diagrams. If you ask nicely, they'll probably even print a few of the pages for you.The radio harness pin-out for 1992 and earlier models (1994 and earlier in North America) can be found here:* http://www.surrealmirage.com/vrg3/bcstereoThe radio harness pin-out for 1993 and later models (1995 and later in North America) can be found here:* http://ae64.com/Legacy-pinout.htm
1-3-4-2 is the firing order.
If the duse is still good ... then remove the door panel and try cleaning the area ... remove the unit ... clean around the bolt areas. It is probably not getting a good dround. You may have to run a new ground wire..(from one of the bolts to some good metal somewhere handy)Make sure the motor is still operational ... they don't give out often, but they do sometimes. It is just a typical GM unit ... one can be found at a salvage yard.
There are two 2.0 litre engines that have slightly different plug gaps. You should be able to identify yours from the handbook,the X20 has a gap of 0.9 to 1.0mm. The C20 has a gap of 0.7 to 0.9mm. Don't bother if you can't identify it,just gap to 0.9mm and it will be ok.
The population of GLS bank is 407.
GLS bank was created in 1974.
Any of the 4WD Subaru GLs are primary front wheel drive with either mechanical or electromechanical actuation of the rear drive axle. So, in 2WD, only the front wheels drive the car.
Yes, the body parts of a 200 Jetta GLS can fit on a 2002 Jetta GLS with little fabrication.
You want to take that to a specialist. You might have to replace it