answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where do screws go in a water pump for a s10 truckyear 1988?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the water pump on a 1988 Cadillac DeVille?

replacing the water pump on the deville is no easy task if you can avoid doing it yourself take that option it is an aluminum block that the water pump is bolted to when you take the housing and screws off its a pain to get them back go to a trusted pro labor is around 350 but water pump is enexpensive


Where is the washer pump on a 1988 Monte Carlo?

The washer pump on a 1988 Monte is located in front (attached) of the wiper motor. Three Torx screws removes it. Tony E.


Where is the fuel pump on a 1988 Toyota 4Runner?

I have a 1988 Toyota 4-runner,and the fuel pump is in the tank. It is very easy to change. All you have to do is just lift up your back seat and on the passengers side there is a compartment with 3 screws. Then you take out the screws,pop off the cover, and there is your fuel pump! cowgirlunlimited


Do you have to remove power steering pump on 1996 Pontiac Bonneville 3800 to replace water pump?

No, you don't have to remove the power steering pump to remove water pump. You do have to loosen the 2 screws that hold the power steering pump and then move power steering pump about an inch or so, so you can have access to some of the screws that hold the water pump on.


How do you replace the water pump on a 1988 Pontiac Le Mans?

The water pump on a lemans is ran by the timing belt. The pump is not like a conventional water pump being that the housing is actually cast into the block the pump itself is just an insert that goes into the block. You have to take loose 3 Allen head screws and pull the pump from the housing there should be an o-ring on the back your new pump should have one. Put all of it back in reset the timing and replace the timing belt remember the water pump drive sets the tension on the timing belt so put tension on the gear and tighten the Allen screws and you're done


How do you change a water pump on an 1988 corvette?

== ==


What is the plug that screws into the water pump on a 96 impala ss?

Water temperature sensor.


How do you replace the water pump on a 1987 Cadillac Seville?

How do you replace the water pump on a 1988 Cadillac Seville?


How do you replace a water pump on a 1988 dodge ram B150 3.9l V6?

Drain the water from your 1988 Dodge Ram cooling system. Remove the water pump belt. Remove the water return hose. Remove the water pump retaining bolts. Reverse the process to install your new water pump.


How do you replace a water pump on a 1988 Buick Regal?

no


Where is the water pump located at on a 2001 Dodge Ram 1500?

The water pump is the part that the radiator fan screws onto on the front of the engine.


Where is my 1988 VW beetlewater pump located?

The 1988 VW Beetle, not sold in the U.S., has an Air Cooled engine. It has no water pump.