Hi, We are Exporters of Auto Spare Parts based in Mumbai, India.
The Engine seal are available with us.
We also stock the complete range of spare parts for :
Mazda T3500
Mitsubishi Canter 4D31
Toyota Dyna / Coaster
etc.
Contact us for your requirements
Mr. Huzefa
M/s Supreme Motors
Tel : +91 22 23877315
Cell : +91 99672 03055
mail@suprememotors.in
You don't use clutch fluid for a manual transmission vehicle.
To set the injector pump timing on a Mazda T3500 truck, you will need to follow these steps:Locate the timing marks on the flywheel and the injector pump gear.Rotate the engine until the timing marks on the flywheel and the pump gear align.Loosen the injector pump mounting bolts and rotate the pump until the timing mark on the pump gear aligns with the timing mark on the flywheel.Tighten the mounting bolts and recheck the timing marks to make sure they are still aligned.Start the engine and check for proper operation.It is important to note that the procedure may vary depending on the specific model and engine of your Mazda T3500 truck, and you may need to consult the vehicle's service manual for specific instructions. It's also important to make sure to have the right tools and expertise to do this job
It is 750kg
Mazda used the ford ranger body but used the Mazda engine.
A Mazda B3000 truck does not have a non interference engine. These engines are designed to survive catastrophic timing failures due to lower tolerances.
Mazda named their truck models by engine size, so a B2300 is a 2.3 liter engine.
ODO
The Mazda B2200 truck body did not change much, if at all between 1986 and 1993. There should be no differences in the shape of the engine compartment. -Kyrasis6 Owner of Mazdatruckin.com
Not sure, I think Mazda Titan is the same as Ford Trader. The Titan is a rebadged Isuzu Elf
Its Located Rite Behind The Engine. STUPID!!!!
under the termostat housing.
Worn or destroyed engine seals - Piston, Valve, Heads etc.