American Cars
Oil and Oil Filters
Fuel Filters
Chevy Silverado
Chevy Trucks and SUVs

Where do you add the engine oil on a Chevrolet silverado?

567

Top Answer
User Avatar
Wiki User
Answered
2007-12-04 20:54:00
2007-12-04 20:54:00

in the hole in the valv cover

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


While owning a vehicle is important to know the engine oil capacity. In a 1991 Chevrolet Silverado truck the oil capacity is five quarts of oil with the filter change.


It is on the bottom of the oil pan, and the oil pan is on the bottom of the engine




Drivers side, oil pan is concaved and the filter is at the top against the engine.


It is in the oil pan and that is bolted on the bottom of the engine. Just look around the bottom of the oil pan and you will see a bolt in it. And that will be it.


Yes, 20 W 50 motor oil can be used in a 2001 Chevrolet Silverado with a 5.3 liter engine. This oil is great for older model vehicles.


You change the 2008 silverado oil transmission whenever you take it for service.



It is screewed into the top of the engine block right behind the distributor. It is hard to get to.


Remove the crankcase breather cap up in front of the engine and add motor oil down the tube.


An 8 cylinder Chevrolet Silverado needs 5 quarts of oil for an oil change. This includes the small amount of oil stored in the oil filter when changed.


5W30 weight ONLY. Anything heaver will BURN up the valvetrain.


There is a cap on the valve cover that says oil or has a picture of an oil can. Remove the cap and add oil.


5.75 quarts with a new oil filter


If you slide in behind the drivers side front wheel and look up at the engine you will see it.


It is on the back side of the oil pan on the drivers side. Look for the lowest point of the oil pan and you will see it.


Slide in under the truck behind the drivers side front wheel and then look up at the side of the engine and you will see the oil filter.


If it is the 4.3 liter engine and you have drained all the oil out of the engine oil pan and you have replaced the old oil filter with a new oil filter, then you need to add 5 quarts of engine oil to get the proper level in your engine.



It is bolten to the engine block, just above the oil pan, on the very front of the passenger side.


Below the oil pan. If you do not know you should not touch it.


What size of oil filter do i need for a 2004 Chevrolet 2500 HD silverado


Center rear of oil pan, It is a cast alumium pan the oil filter will be just left and up from it.15mm bolt.


not a nice job to change oilpan on a chev, u need to unbolt engine mounts and jack engine up so u get enuff clearance to remove oil pan



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.