0
Where do you find the 01 Chevy Venture blower fan resistor for the high setting and how do you replace it?
Wiki User
∙ 13y ago
Hi,
The Blower Motor Resistor pack is mounted right next to the blower motor.
You have to remove the insulator panel from the passenger side floor board area to get to the blower motor and the resistor pack. Once you have that off, the resistors and blower motor are near the firewall, and can be removed by taking out the screws that hold them in place. I believe there are 3 or 4 screws that hold the motor and 2 screws for the resistor pack.
There should be a "Related Link" at the left of this answer that will give you more details.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Heater fan switch works only on the highest setting?
The blower motor speed resistor is burned out. You can replace only the resistor but the resistor probably burned out because the blower motor is going bad. If you want to fix it for good, replace both the blower motor and blower motor speed resistor.
Where is the Blower resistor 2002 venture van?
The blower resistor is located under the dash, near the floor, on the passenger side of the vehicle. I had to replace the resistor about a year ago. It is not an easy place to work in. You have to remove the blower unit in order to get at the resistor. Not fun, but rewarding when you actually do it yourself.
Why is your blower only works on the highest setting on your 2001 Dodge Durango Sport?
You need to replace blower motor resistor.
How do you replace a fan blower resistor on a vauxall Corsa?
How do you replace a fan blower resistor on a vauxal Corsa?
How do I fix 1997 k1500 Chevy truck blower that only works on high fan setting?
The blower motor resistor pack is defective. Replace it.
Why does the blower stay on when my 99 Chevy venture is off?
A common cause for this is a burned out blower resistor. Tech JK --------------------------
Where is the heater resistor located on a 2000 Chevy Venture van and were is the best place to buy a fanac control switch?
resistor usually located by blower motor.blower only works on low or high,then replace resistor .do not replace hvac unit in dash waste of time and money
Your car was leaking water on the resistor so you fixed the leak and replaced the resistor and in the mean time before the resistor got replace the fan would only kick on on the highest setting but on?
The old resistor was burned out. If you burn out the new one again, replace the blower motor.
How do you replace a blower resistor on a 2002 BMW 325i?
how to replace blower resister on a 325i BMW 2002
How do you replace blower resistor on a 2006 mustang?
# Locate the blower resistor under the right-side of the instrument panel # Disconnect the electrical connector from the blower motor resistor # Remove the blower motor resistor mounting screws and remove the resistor from the housing # Installation is the reverse of removal
Where is resistor for blower motor on 1997 Chevy venture?
near of blower fan on right side inside the car under dash
Already changed the heater-air controls why won't my heater-air blower work?
have you checked the fuse if so then you will need to replace the resistor for the blower hig and low dettings have you checked the fuse do you have 12 volts to blower if so then you will need to replace the resistor for the blower replace the blower motor
