0
Where do you find the crank position sensor for a 1997 buick lesabre?
Wiki User
∙ 14y ago
its behind the harmonic balancer attached by two bolts but you must first take off the balancer to get to it
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Buick 3800 crank position sensor?
behind the crank pulley
2002 Buick lesabre crank dont start?
what can cause a 2002 buick lesabre to not crank
Where is the crank shaft sensor on a 1994 buick lesabre?
under the crank pulley, right side of car under front of engine
Does a 1994 Buick Skylark have a throttle position sensor or a crank sensor?
It has both.
1990 Buick LeSabre when I am driving it cuts off and sometimes it'll crank back and sometimes it takes a long time I was told it was my coil pack?
My 90 lesabre did the same thing. When it cut off after driving I sprayed water on the crank sensor and it started right back up. A buick mechanic told me to do this and this is how I found out the crank sensor was bad!
Where is the crankshaft sensor on a 1998 buick lesabre?
The Crank sensor in my 91 LeSarre Limited is behind the Harmonic balancer pulley....there are fins on the back of the pulley that line up with the sensor.
Where is the crank sensor located on a 3100 engine buick lesabre 2000?
It's located on the block, just above the water pump
Why would a 92 Buick LeSabre not run turn over after Serpentine belt shreds?
probably damaged the crank sensor, or the tangs on the harmonic balancer
Why does my 1992 Buick Lesabre stop running when it gets warm after driving it for awhile and when it takes corners?
I put a new crank sensor in it, and now it runs great!
What does the Crank shaft sensor on the Buick LeSabre look like 1995?
Check Autozone.com or another such sight They might have a picture. They did for the same part for my 91 lesabre. (Which may very well be the exact same part)
Where is the crank position sensor for a 95 blazer?
Where is the crank position sensor hole on a 2003 Blazer
How do you replace a crank sensor on a 1995 Buick Lesabre?
Remove belt, balancer bolt and get a balancer puller to remove the balancer. Unbolt and unplug sensor to replace it. An air impact wrench that is strong will get the bolt loose.
