Want this question answered?
take off the license plate then screw the holder on with the plate.
on the 2001 XZ3 I removed the license plate and used a flat head screw driver to slid the license plate light cover over and they "pop" out.
The size of the screw needed to mount a license plate on a 1998 Cadillac STS is 1/4-inch?æby 1/2-inch. They make license plate kits that includes all needed hardware.
Changing the license plate bulb on a 2002 Lincoln LS is quite simple. You must first remove the license plate first. Then unscrew the old bulbs and screw in your new ones.
There are screws holding it on. Un-screw them.
To change the license plate lamp on a 1998 Bravada, locate the bulb. Visit an auto parts store to obtain the exact bulb and screw it in place.
license plate light just pops out of the bumper with a screw driver.u can buy a new light at auto store or just change the light bulb
You will be required to screw four screws into your bumper. Either make the holes ahead of time of screw them in with pressure
From the site: http://new.volvocars.com/ownersdocs/2001/2001_S60/01s60_11b.htmLicense plate lights* Switch off the ignition. * Loosen the screws with a torx screw- driver. * Carefully pull out the lamp housing. * Turn the bulb holder counterclockwise and pull it out. * Pull out the defective bulb and insert a new one. * Reinsert the bulb holder into the housing and turn it clockwise. * Reinstall the housing and screw it in place.
Open the box in consol in the bottom remove a little plate with screw driver and you will see the 2 screws
Raise the trunk lid...you will see the lights on each side of the license plate...use Phillips screw driver to remove and replace bulb. Just did this takes about 2 minutes.
there should be little screws that you screw out and they pop out and you twist the bulb to remove it