It's in a package called the constant control relay module - CCRM - under a cover directly in front of the top of the radiator.
See "Related Questions" below for more
On a 1993 Ford Taurus : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver
Were do I locate the fuel filter on a 1993 Ford probe 4 cylinder
Yes, the power goes through the relay before the starter gets it so if the relay is bad, there is no power to the starter.
Under the hood, on the driver's side of the firewall. The relay closest to the master cylinder.
Behind the glove box.
Look under the dash on the drivers side, you shouldn't have to remove anything. The relay is a silverish cylinder. It pulls right out from its mount.
it is mounted above the glove box. I believe you have to remove the glove box to locate it.
Locate the relay under the fuse box and just pull it out by hand. Pop in a new one.
The fuel pump relay can be found under the cooling fan guard, on the driver's side of the car. It's a black box, less than two inches thick and perhaps eight inches long, and it's bolted to the top of the frame that holds the cooling fan, parallel to the frame.
The 1989 Taurus has larger headlights separate from the turn signal(corner lamp) The 1993 Taurus has more slender headlights joined to the corner lamp.
Juste below the brake master cylinder. The Stick is black.
None will work.
picture of the fan relay for 1993 mercury topaz
I had a 1993 several years ago and I think I got about 26 MPG combined city and highway driving.
Under the hood, on the firewall, drivers side, close to the master cylinder.
Which model 1993 Oldsmobile and which flasher relay? Turn signal or hazard relay?Cutlass Supreme and it's the flasher relay
On a 1993 Ford Taurus GL : That would be the 3.0 litre " Vulcan " V6 or the optional 3.8 litre V6
The Ford Taurus.
The 1993 Ford Taurus does have a cabin air filter. It is located near the firewall below the windshield on the passenger side.
For a 1993 Ford Taurus : ( DOT 3 brake fluid meeting Ford specification ESA-M6C25-A )
Should be located under the hood, on the firewall, driver's side, the one closest to the master cylinder.
The starter relay is located between the battery and the power distribution box in the engine compartment (on the fender wall). On later model vehicles, the starter relay is mounted inside the engine compartment's fuse/relay box. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups.
I believe that would be the 3.2 liter DOHC V6 engine that was used with the automatic( from 1993 to 1995 inclusive ) unless you mean the 2010 Taurus SHO with the 3.5 L -V6 - twin turbo engine
Insert the key and turn it to the run position. Under the column there is a small hole that you insert a small punch or a pin up into and press a pin on the cylinder to release it from the housing. If the cylinder is siezed and will not turn, then you are in for a real job. You have to drill out the tumblers to get it to turn. You need to somehow turn that cylinder to the run position to get it out.