through the overflow bottle
Remove the drain plug from the bottom of the radiator. Allow the coolant to completely drained out. Replace the drain plug to its original position. Fill the radiator with new coolant.
Remove the drain plug from the bottom of your 2002 Chevy Camaro radiator. Allow the coolant to drain out into a container. When all the coolant is drained out replace the drain plug to its original position. Fill the radiator with new coolant.
Before replacing the radiator hose on a 1996 Honda Civic drain the coolant system. Once drained remove any clamps holding the hose in place and pull the unit off. Replace with new hoses.
To flush a radiator on an Acura RL you will need to make sure the care is level. Remove the radiator cap from the radiator under the hood. Place a bucket under the radiator and remove the radiator plug. This is a white plug located on the bottom of the radiator which may be hidden by the splash guards at the front of the vehicle. After the radiator fluid has been drained replace the white radiator plug. Refill the radiator with coolant and replace the radiator cap.
That number is the capacity of the coolant system. Even after the radiator is drained there is still about 3-4 quarts in the engine and heater core lines. to completely replace all coolant you will need to flush the system with water and consider the remaining water in the system into your 50-50 mix ratio.
If the hoses are all tight, Then the radiator must be leaking. REPLACE RADIATOR
It is in the passenger side coolant tank on the radiator. If the light is on and the coolant is at the proper level then the sensor is defective. To replace it you will have to drain the radiator. Disconnect the wire and remove the clip and remove the sensor.
already have it loose
Yes, only if they have the same engine.
replace the radiator correct, the radiator is junk.
Open the drain out valve at the bottom of the radiator to allow the coolant to run out. Replace the valve and add the fresh coolant.
The thermostat on a 1996 Jeep Grand Cherokee 5.2L is replaced by draining the coolant and disconnecting the radiator hose. The housing is then unbolted, the thermostat removed, and a new unit put in its place.