0
Where does the negative battery cable go on a 1996 ford crown Victoria?
Wiki User
∙ 14y ago
One cable should go to the frame, and the other to the engine.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why is there no electrical power on 1997 Crown Victoria?
Bad battery cable connection or dead battery
Where is the starter relay located on a 1997 crown Victoria?
Could be on the inner fender - follow the + battery cable
Why wont your 1998 Crown Victoria crank?
Do any of your lights work ? or if the key is in the ignition and the drivers door is open do you hear the warning chime ? If not , it sounds like a bad battery cable connection or a dead battery
How do you replace the parking brake cable on a 08 Crown Victoria?
very carefully
Where is the relay switch on a 1983 ford crown Victoria?
The starter relay switch is attached to the short positive battery cable; just follow it to the starter relay. I hope this helps you. Mark
How do you restart computer on Crown Victoria?
Pull off the battery cables and replace
98 Crown Victoria won't start Key turns but no crank?
Does your underhood light come on ? or if the key is in the ignition with the drivers door open , do you hear the door chime ? If not , it sounds like a bad battery cable connection or a dead battery
Change starter 1994 ford Crown Victoria?
Remove - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter
What does it mean when the battery gauge reads high in your ford crown Victoria?
Voltage regulator is defective. Have it replaced or this will ruin your battery.
What does it mean when your battery light flashes on your 1988 crown Victoria?
Check the volts right from the battery, might be a faulty alt.
How do you change the battery on a 1990 Ford Crown Victoria?
if it has the stock terminals, you need a 1/2" wrench. disconnect the terminals, starting with the negative (black). then, disconnect the red (positive). use a 10mm socket to remove the bracket that holds the battery down, and pull the battery out. put new battery in, put positive terminal on first, then negative, then put on bracket.
Where is the tach signal wire on a 1998 Crown Victoria?
If your car has a distributor it is the negative on the coil.
