The clutch master cylinder should be attached to the firewall, nearest the drivers side, inline with the clutch pedal. In the engine compartment, look for a smaller version of the brake fluid reservior.
Does my 1995 Toyota Paseo have a clutch cable
In the clutch master cylinder next to the brake master.
If it does not have a Hydraulic clutch, then it has no fluid. If it has a Hydraulic clutch the clutch master cylinder is normally located on the firewall, driver's side, near the brake master cylinder.
The clutch reservoir on a 1995 Toyota will be found on the slave master cylinder. These are located on the firewall of the engine bay.
What about the master cylinder? They go out, ha. That's all I can help you with though.
master cylinder on the gearbox vr6
The clutch gets its fluid from the master brake cylinder reservoir. The master clutch cylinder sits just below the master brake cylinder reservoir and is fed fluid by gravity.
On the firewall next to the brake master cylinder.
Answer: Normally located down by clutch arm (that sticks out between the engine and transmission). How do you locate it? The clutch pedal depresses a clutch master cylinder on the firewall (driver side). Follow the hose line down to the where the clutch arm is located. NOTE: don't get the brake master cylinder and clutch master cylinder confused, its easy if you do not work on cars regularly.
Bad clutch slave cylinder or failed soft hose from master to slave cylinder.
There are two normal causes. The clutch is worn out or there is a leak in the hydraulic clutch slave or master cylinder. To check the clutch, press the clutch slave cylinder down. If the clutch slave cylinder bellows compresses down to the slave cylinder, the clutch is worn out. Check the clutch master cylinder fluid level. if this is low, then the clutch cylinder need to be checked. To check for a hydraulic leak in the clutch slave cylinder, remove the cylinder's bellows and check for any fluid. If fluid is present, rebuild or replace the cylinder and bleed the system. To check the clutch master cylinder, check the back the of clutch master cylinder for leaks. If fluid is present, replace or rebuild clutch master cylinder and bleed the system. In my experience, hydraulic leaks occur at the clutch slave cylinder.
Remove clutch cable connection and then remove slave cylinder line from master. Then unbolt slave master and remove it. Follow same procedure in reverse order.