0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the PCV valve located on a 1991 Buick Regal Custom 3800?
the PCV valve is located on the valve cover of a 1991 Regal Custom. It is plugged in and can be easily changed.
Where is the pcv valve located for a 2003 buick Lasaber 3800 series ii motor?
If you remove the 3800 series plastic cover, look to the left of the intake manifold directly in front of the alternator. You will see an electrical connection-this is the MAP sensor, which is clipped into place. Remove the MAP sensor by unclipping it and pulling it out, and then twist and remove the PCV valve cover right underneath the MAP sensor. The PCV valve is right underneath that cover. Pop it out and replace it, and put the PCV valve cover back on along with the MAP, and finally replace the 3800 series cover and you're good.
Where is the PCV valve located on a 1997 Pontiac Grand Prix?
it is on the rear valve cover.very hard to get to..The pcv valve is not visible on a 3800 series II engine, which I presume you have in your Grand Prix, because it is located under the MAP sensor. You will find that at the front of the engine, where the serpentine belt is located. Unplug the connector to the MAP sensor and then you will have to unclip the sensor itself. You will then see pcv valve underneath.3For a 3800 normally asperated check out the following website for pics and instructions. http://www.scacgp.com/mods/gt_pcv.htm."G"
Where is the PCV valve located on a 1994 Buick Regal Custom 3800?
The PCV valve on a 1994 Regal Custom should be located on top of the valve cover. It is a plug in type and is easily changed.
Where is the Gm 3800 series 3 crank position sensor located?
Undecided QuestionShow me another » Where is the camshaft position sensor located on a 1997 pontiac with a 3800 motor
Is there an egr valve in 1992 Pontiac Bonneville and where is it located could a bad valve keep you car from starting and running properly?
AnswerThe 3800 (RPO: L27) was not equipped with an EGR Valve for the model year 1992 only. The 3800 (RPO:L67) does have an EGR valve.The valve should be located on the driver's side on top of the manifold.A bad EGR valve can keep your car from starting and running properly.
Where is the egr valve located on a 3800 series gm v6 engine?
behind the throttle body...it looks like a motor facing downward toward the exhaust manifold. it connects the tube from the exhaust to the lower intake.
Where is the thermostat located on a 1998 Buick Regal?
Depends on the type of engine, but in 3800 type, remove the plastic hood (the one that bears the number: 3800) and the thermostat housing should be on the right side. Follow the upper radiator hose, it is connected to it. On the thermostat housing, you will also find the air bleed valve of the engine.
Where is the PCV valve on a 1996 Chevy Camaro 3800 v6?
On a 1996 Chevy Camaro, the PCV valve is located on the right side of the valve cover. There is a hose that runs from the PCV valve and connects to the back of the intake manifold.
What is the difference between the 3800 series 2 and 3800 series 3 gm engine?
About 20hp.
What is the difference between the 3800 series II engine and the 3800 Series III engine?
About 20hp.
Where is your PCV valve in your 97 Pontiac firebird v6 3800 series?
Is on the pas danger side of the intake a little being the throttle body
