On the end of the intake manifold, passenger side.
The passenger compartment fuse panel is located on the driver
The coolant level sensor is on the bottom of the coolant reservoir located on the passenger side fender well.
located on the passenger side of the bellhousing. It detects notches on the flywheel/driveplate
They are located on the passenger side. Sensor1 is right past the exhaust manifold, and sensor 2 is after the cat.
Back of the trans, in the housing that the passenger axle goes into.
It is located on the top of the passenger side dashboard. It is fitted into the speaker grille
The bank 2, Oxygen sensor 2, on a 1999 Mitsubishi Diamante is located on the passenger side of the vehicle. It is in the exhaust in the undercarriage.
It is on the passenger side of the valve body, inside the transmission.
It is located in the front of the engine on the cylinder head. It's located on the passenger side of the vehicle.
It's located on the passenger side, backside of the engine underneath the air intake manifold.
passenger side of trans right above the axle housing
it is mounted to the strut tower between it and the firewall on the passenger side
Where is located pressure sensor on Chevy Malibu 1999
It is the transmission output speed sensor, which is located on the front of the trans far driver side.
It is under the front of the passenger side cylinder head
Bank 2 is passenger side. O2 sensor 1 is threaded into the exhaust system between engine and catalytic converter.
The crankshaft sensor on a 1999 1500 Ram is located under the passenger side head towards the back. If you can locate the valve cover you are on the right track. It will be below the valve cover.
The output speed sensor circuit runs from the sensor, on the driver side of the transmission, to the engine computer. The computer is under the hood on the passenger side firewall.
There are 4 O2 sensors in 1999 suburban.Bank 1 sensor 1, bank 1 sensor 2 on the driver side before Catalytic Convertor. Bank 2 sensor 1 on exhaust Manifold, passenger side. Bank 1 sensor 3 is after catalytic convertor.
Ambient air temp sensor is located on the passenger side at the front of the jeep, just in front of the rad behind the grill.
It is under the front of the passenger side cylinder head.
A 1999 Dakota does not have a mass airflow sensor.A 1999 Dakota does not have a mass airflow sensor.
It should be located on the passenger side of the transmission bellhousing, about midway between the top and bottom of the bellhousing.
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue