Blower Motor Removal & Installation With Air Conditioning 1. Disconnect the battery ground. > On trucks built for sale in California, remove the emission module located in front of the blower. 2. Disconnect the blower motor wiring at the blower. 3. Disconnect the cooling tube at the blower. 4. Remove the 4 mounting screws and pull the motor from the housing. To Install 5. Remove the clamp from the blower case and remove the blower cage. Mount the cage on the replacement motor. 6. Install the blower motor and tighten the 4 mounting screws. 7. Connect the cooling tube and wiring hardness. 8. Connect the negative battery cable. Check the blower motor for proper operation. 9. Cement the cooling tube on the nipple at the housing using Liquid Butyl Sealer D9AZ-19554-A, or equivalent.
Blower motor fuse is blown. Blower motor resistor burned out. Blower motor switch bad. Blower motor bad.
search up the diagram
blower motor bad or no power to it chech fuses blower switch blower motor
try replaceing the switch that controls the low to high for heater It's gonna be the blower motor resistor (near the blower motor).
you have waisted my time, thank you
where is the blower motor resistor located on a ford e250 2001
Bad blower motor fuse? Bad blower motor resistor pack? Bad blower motor - checck to see if it is getting power--if so bad motor Bad switch?
below glove box remove heater/air conditioning cover then remove blower motor cover
FUSE!
Normally when a heater blower motor only works on the High setting, it is caused by a defective Blower Motor Resistor Pack. The fix is to, Replace it. In very rare instances it can also be a defective blower motor speed control switch, but rarely.
The resister for the 2001 prism blower motor drops voltage to the blower motor. This is how the blower motor runs at a lower speed.
Blower Motor Resistor is located under the hood on the fire wall behind the right valve cover and the heater hose. It's about the size of a deck of playing cards.