0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How to Change fan blower motor on a 1983 Chevy Celebrity?
Are you asking about the heater blower motor or the engine cooling blower motor?
Where is the ignition control module located an a 1983 Chevy blazer?
Where is the control module located on the 1983 Chevy blazer
Can a 1983 Chevy blazer run on E85 fuel?
NO!
What is gross vehicle weight of Chevy blazer 2 door 4x4?
The gross weight for a Chevy Blazer 2 door 4x4 is 5300 pounds. The Chevy Blazer was produced from 1983 to 2005.
Wiring diagram 1983 Blazer?
The wiring diagram for a 1983 Chevy Blazer can be found in the service manual. It contains a detailed layout of where each wire goes and its function.
What kind of transmission fluid and how much for a Chevy 1983 blazer S-10 take?
A 1983 Chevy Blazer transmission will hold 12 quarts of transmission fluid. The manufacturer recommends using a. SEA certified transmission fluid.
How do you replace the front blower on a 1983 Chevy G20 van?
Looking at the procedure in my 1980 GM service manual and comparing it to my 1984 G20 van, it apears to be simple process. 1983 should be very close. Negative battery cable must be disconnected. Coolant recovery tank and power antenna need to be removed. Blower motor lead wire is disconnected. Blower motor mounting screws (number may vary) are removed. Blower motor and wheel (cage) are removed as an assembly by prying gently on the blower flange. The sealer may be damaged in the process. The wheel can be removed from the motor. Apply new bead of sealer to the entire circumference of the mounting flange of the new motor. Installation is reverse of removal.
What door latches are universal for a 1989 Chevy s10?
Any 1983 - 1993 S10, and 1983 - 1994 Blazer, Jimmy, or Bravada.
Where is the blower moter on a 1983 s10 Chevy truck?
Under the hood, passenger side of firewall,
Can you swap everything form a 1990 Chevy motor to a 1983 motor?
yes, but you have to do some fabrications to the motor mounts.
How do you bleed the clutch on a 1983 Chevy s10 blazer?
The same way you would for brakes. Pump the clutch 4 or 5 time and hold down then open the bleeder valve to release the air. Is it the 2.8L V6 motor?
Why makes a 1983 Chevy S10 Blazer 2.8 V6 stall when the accelerator pedal is depressed?
Your 1983 Chevy S10 Blazer might stall when the accelerator pedal is depressed because of a clogged or dirty fuel filter. Gas that is mixed with water or condensation from the tank can also cause this issue.
