The heater core is located in the heater box which sits up against the firewall behind the dash board, you have to remove the dash to remove the heater box
The 1988 Mazda 323 1.6L non-turbo EFI engine requires an electric fuel pump, which is located inside the gas tank.
If it is the WL turbo engine it is located right under the turbo
A 2006 Mazda Speed6 with a 2.3 liter 4-cylinder engine had 274 hp and 280 lb-ft of torque. That engine had a turbo.
on the timing cover sensing the damper
its a turbo charged 3 liter engine
yes you can put this turbo on but u will have to make sure u are putting the fuel that the engine needs so u don't lean burn the engine and blow it up
The block heater is on the passenger side below the turbo
You will need a special wrench to get the giant nut in the center off. It is torqued to 300+ lb-ft.
As long as its the FC3S model it will fit.
there a 1.6 liter and a 2.0 liter. The 1.6 liter is the GA16DE (Naturally Aspirated) & GA16DET (Turbo version) The 20. liter is the SR20DE (Naturally Aspirated) & SR20DET (Turbo version)
$2000+ at the mazda dealership
you can turbocharge basically any internal combustion engine, including rotaries, as Mazda did for quite a few years with their wenkel 13B 1.3 liter motors.