Want this question answered?
you have to remove the dash and every thing attached to it. Is it the same for a 1988 Mazda 929?
It is important to know as much as possible about the car that it is driven. Yes, there is a clutch adjustment on a 1991 Mazda 929.?æ
The thermostat, on your 1992 Mazda, can be found on the front bottom portion of the engine. You can follow the water hose from the bottom of the radiator to the thermostat.
The thermostat on a 1993 Mazda 929 is located on the top of the motor just before the manifold covers. Look for the largest hose coming from the radiator at the top and trace the length of the hose back to its connection to the motor and the thermostat is at the point the hose connects to the motor.
put ignition key into driver's door to unlock postion.
The Thermostat is located at the low side radiator hole housing ( one end of the hole is connect from the radiator and the other end is connect to the housing
What is a timing cover seal on a 1992 mazda 929 and where is it located at?
929 1990 Mazda power brakes fails
WHATS THE TIMING MARKS ON 93 MAZDA 929
Remove the two 12mm bolts with a socket and extension. Loosen the upper radiator hose from the thermostat housing. Pull out the housing, remove the old thermostat, and put in the new one. Be sure to get the steel gasket in the same way it came off. Replace the two bolts, tighten the hose and add water and antifreeze.
Probably leaking heater core.If not repairable get one from junkyard.
It's where the lower hose meets the engine!! follow the upper radiator hose to the engine, and it is under a dome where the two meet.