You don't have a cap on the radiator. The cap is located directly on the coolant bottle
bottom of radiator
there is no radiator cap only an over flow cap on the pass.side straight up from the pass.wheel
theres no cap on radiator~ it is filled through the recovery tank on the fender well.
On the coolant overflow bottle
On the plastic overflow bottle
There is no radiator cap. The cap is on the coolant resivuar bottle on the passenger side under the hood next to the firewall
You can find the radiator cap for a 95 Grand Am at various auto parts stores. You can also find replacements through Pontiac dealerships.
Its located on the radiator passanger side about 3" below the radiator cap.
The camshaft sensor on a 1993 Pontiac Grand Am is located behind the rear bearing cap. It detects the position of the camshaft as it rotates and relays this information to the computer.
Add the coolant into the coolant reservoir. Be sure the engine is cool when you remove the cap off the reservoir.
there may not be one if there is is it on the bottom side and if it is not you candrain it by removing the bottom rad hose The 1999 Pontiac Grand Am does not have a radiator drain valve. To drain the radiator, remove the lower radiator hose. The engine should be cold and the water fill cap removed for venting. I have a 2000 Pontiac Grand AM and radiator drain cock is located at the lower/front (not bottom) at the curbside of the radiator, you will need a hex key to back out petcock. .
The thread on cap on the engine coolant reservoir is the " radiator cap " on a 1995 Mercury Grand Marquis
On a 1993 Lincoln Town Car : The threaded cap on the engine coolant reservoir is the pressure cap / radiator cap
On a 1997 Mercury Grand Marquis : The thread on cap on the engine coolant reservoir is the 16 PSI pressure cap / radiator cap
On a 1997 Mercury Grand Marquis : The thread on cap on the engine coolant reservoir is your 16 PSI pressure cap / radiator cap
If the engine is cold... it could mean that the radiator cap is too weak to hold and you need to get a new one. If the engine is HOT... it could mean that you have overheated it and you need to add water after the engine has cooled a bit, to prevent getting burned, be careful and use a towel to remove the cap to add coolant.
There is not one. You just have to loosen the bottom radiator hose and open the fill cap on the antifreeze reservoir when the vehicle is cool.
To bleed the cooling system on a Pontiac 2.4 engine, there is a small hose near the bottom of the radiator that needs to be removed. Then remove the radiator cap and the cap on the radiator overflow tank.
i had replaced that one it is your resivor cap that year did not have a regular radiator cap its only 10.00 but yes its the resoivor cap
follow the hose from the radiator top to the radiator fill cap....undo the cap and you will see the thermostat sitting right there...pull up on the metal kind of handle and the thermostat is out!! lane
The thread on cap on the engine coolant reservoir is the pressure cap / radiator cap for the engine cooling system
I am not trying to sound stupid, this is my question. There is a radiator cap and the overflow bottle as well, but the cap only turns slightly but will not lift off, and before I break something I just want to know that it will come off.
No! Just a draincock on the bottom!
Most radiators are located in the front of the motor, there should be a cap on one side or the other of it to add water.