It's on the passenger side of the car.Behind the glovebox,you will have to take the glovebox off the dash.then you will have to lay on the floor on your back,looking upward by the firewall you will see the blower motor.look behind the blower motor you will see a wire harness conected to the blower motor.Thats the resistor,after you un hook it from the blower motor you will have to take the blower motor out.It's held in by three screws,once you have taken the blower motor out,follow the wire harness that you've taken off the blower motor.you will then see the resistor with much effort its easy to get out,it's held in with two screws,you will only take one screw out to get the resistor out.
Right next to the blower motor
on the passenger side under the glove box
where is the blower motor resistor located on 97 buick skylark
The blower motor resistor is over the passenger side strut tower, under the hood.
The resistor is located to the lower right of the blower motor. You will need to remove the battery to access it
change the blower motor resistor. done deal.
They get noisy, squeal and vibrate. Also if you keep burning out the blower motor resistor, that is a sign the blower motor is on its way out.
You probbably have controler problems but the resistor is on the evaporator case.
Defective blower motor resistor pack.
Replacing the 1997 Chevrolet suburban blower motor resistor can correct your air output issue. The air output issue could because by other things.
Locate the resistor under the hood near the blower motor on passenger side firewall. Unplug the electrical connector. Remove the screws holding the resistor in place. Remove the resistor. Install in reverse order.
near of blower fan on right side inside the car under dash