The C115 sensor is located right above the wiring harness in a green clip.
It is located directly above the transmission. There is a detachable wire harness.
It is located on the top of the transmission, you can access it without removing the transmission as it is connected to the engine wiring harness.
The oxygen sensor on a Honda Civic is replaced by disconnecting the wiring harness and removing the sensor using a socket wrench. Anti-seize paste is applied to the threads, a new sensor is torqued into place, and the wires reconnected.
The IAT sensor on the 1993 Honda Prelude is located to the right of the intake manifold as you face the engine compartment. It is connected with red and green wiring.
Crankshaft sensor on Honda/Isuzu 3.2l V6 is located on the lower passenger side engine block . If you look through the wheel well at the block just behind the motor mount you will see the wiring harness plug going in.
The VSS is located on the top of the transmission and is connected to the engine wiring harness. To replace it all you need to do is unplug the old one from the wiring harness and unscrew it from the transmission, instalation is the reverse of removal.
The oil pressure sensor on a 92 Honda Accord is replaced by disconnecting the wiring harness and unscrewing it using a wrench or socket set. The replacement sensor is then put into place and torqued back to specs.
The bank 1 sensor is located front and center on your engine. It looks somewhat like a spark plug. It has 3 wires leading into it from a wiring harness located about 12 inches to the left of the sensor. It is at the top,front of the engine,partially covered by your exhaust shroud.
The wiring harness from the 1999 stereo has a 21 prong plug and the 1995 has a 14 prong plug you can purshase a harness from Honda but it has to be hadrwired to the exsisting wiring but don't screw it up, go to Honda and get a wiring diagram for the both of them to match up the wiring you need to make it work.
if you have the F22B1 (97EX 2.2lVTEC) engine , the front 02 sensor is located below the exhaust manifold on the front of the engine, it has a wiring harness attached to it, and is screwed into the exhaust pipe from the top, before the Catalytic converter. the rear O2 sensor is located AFTER the catalytic converter, and is attached similarly.
Where is the LAF sensor located on a 92 honda civic?
vss= vehicle speed sensor. try the wheel.. id say there is nothing wrong with the sensor itself.. try the wiring