It is on the top rear of the transmission bell housing.
1391 is for an intermittent loss of the cam sensor or crank sensor signal
It is on the top rear of the transmission bell housing.
where is the crank sensor located on my 1997 Chrysler sebring lxi
It is on the top rear of the transmission bell housing.
Possibly the crank sensor or the coil pack is dead. But with a dead crank sensor you also get no spark, no crank. No crank equals no fuel delivery.
There is a tone wheel on the crank/flywheel that the sensor reads off of, if that is your question.
The most common would be engine cranks but does not start.
is your car is a v6 2.7 it will be on the trans mission by the EGR
It is on the top rear of the transmission bell housing.
It's in the top of bell housing of the transmission near the back of the engine compartment.
Out of gas, fuel pump, cam sensor, crank sensor, coil, computer, alternator, etc.
No, the crank sensor reads crankshaft speed. The cam sensor reads camshaft speed. The cam sensor is on the distributor on a 1999 2.5L