ok the egr valve it under the back cover covering your car ..efi w/e it is i just recently replaced mine. once you take the cover off there its a little round thing that looks like a UFO or a bell it one wire connecting into it it it directly in front of your firewalla nd right behind"little to the left" on the driver side behind the car..efi w/e but when u replace the egr valve make sure u brush out the old carbon on the intake there that's a must! don't not forget! if u got ne questions email me i will take pics and send them 2 you if need be email@to_hard_core@Yahoo.com thanks
nope has to be the 32 valve engine
The EGR valve, on a 2004 Ford F150 5.4 liter engine, is located on the top of the engine near the back. The valve is difficult to identify without prior mechanical knowledge.
Need more info. Which valve are you referring too?
there is no 6.2 engine
On a 1997 Ford Ranger , 4.0 EFI engine : The PCV valve is on the top of the drivers side engine valve cover , near the rear
a 2 valve engine , the 3 valve 5.4 L is used in 2004 and newer F-150 Ford trucks
about 5 qts
Look under the vehicle and count them.
The PCV valve on a 1993 F150 is located in the top of the valve cover. it is a plug in type, and is easily replaceable.
Front drivers side of engine.
The 1997 Ford F150 4.6 liter engine throttle position sensor is located on the top of the transmission. The sensor will be connected to the fuel injection rail.
what is valve of ford truck F150 1986
PCV Valve is located on the Right Valve Cover.
With engine oil filter change ( 6 quarts / 5.7 liters of engine oil )
Click the link and choose your engine size.
I believe it is on the valve cover , drivers side of engine , towards the rear
no have , per wiring diagram.There is no IAC motor for this engine and I suspect you have an error code
No, a 1997 Ford F150 doors will not fit on a 2001 Expedition. You will need to get a door that is made specifically for the Expedition.
where is the heater control valve for a 1997 ford expedition
There is no valve lash adjustment (per se). Torque the rocker arm fulcrum nuts to 23-29 ft. lbs.
a 5.0 is a v8 engine, so there are 8 intake valves.each cylander has 1 intake and one exhaust valve in the head. to install a valve the head must be removed from the engine block
It is located in the engine compartment on the passengers side firewall. the solenoid is located under the hood
( 6 ) quarts with engine oil filter change
The 4.2 L - V6 engine used in the 1997 Ford F-150 is an OHV ( overhead valve not an overhead cam ) if that is the engine you are referring to ?
The PCV valve is located on the top of the 97 5.0 Ford v8. It is near the firewall at the middle of the engine from side to side.