The Starter motor on a fuel injection Hyundai Pony/Excel is located below the inlet manifold coming from the injection system. It is difficult to access and the only way to get there is by removing the actual inlet manifold.
I can't say were because I'm yet to look but if you follow the positive terminal it should lead you there.
how to change starter on Hyundai scoupe 1993 12 valve
It can be found at the back of the engine about half way down the block, you will need to jack the car up to get to it, if you need to change it out. hope this helps.
on the front of the motor under the exhaust manifold
Hyundai Excel was created in 1985.
Hyundai recommends SAE 10w40. On a car this old I recommend you use a High Mileage oil.
To get the radio code for the Hyundai Excel you need to request it from Hyundai.
under the manifold, left side of the motor. 2 bolts is all you need to undo it. You may have to take some hoses off to get to it
you're an idiot
# Disconnect the negative battery cable # Remove the air intake duct and the air cleaner assembly # Disconnect the speedometer cable from the transaxle # Unscrew the nut and disconnect the battery cable from the starter motor then disconnect the wiring from the solenoid # Remove the starter motor mounting bolts,supporting the starter motor as the bolts are removed and remove the starter motor
# Disconnect the negative battery cable # Remove the air intake duct and the air cleaner assembly # Disconnect the speedometer cable from the transaxle # Unscrew the nut and disconnect the battery cable from the starter motor then disconnect the wiring from the solenoid # Remove the starter motor mounting bolts,supporting the starter motor as the bolts are removed and remove the starter motor