Where is the IAT sensor on a 93 Grand Prix SE?
I cannot give you and exact location for the 93 but i can tell you that it will be on the air intake tubing or right near the throttle body...on my 96 it is on the intake tube closer to the throttle body..hope it helps a little
Where is the iat intake air temperature sensor plug on a 93 Nissan 240sx Ive gotta put this racing chip in before Friday?
1993 Grand Prix and you know there are struts on the front but what is on the rear of the vehicle and you have the B4U package on your 93 SE cpeThanks?
Look under the Mainfold and it should be a screw on sensor.....it also might be in a black box protected under the manifold its usually in plain sight but consealed by the box. Edit from someone else: I have a BMW 1995 318is with the same engine (if you're in the US). The engine is M42 and was used on '92-'95 318 BMWs. The IAT sensor is integrated into the volume air flow sensor, it…
There were two areas these could be mounted in the various cars. Some are mounted on the back of the intake plenum. The other location will be the firewall. It's a small black "box" about 3" long and 1 1/2" wide. It will have wires running to it and 1 vacuum hose. These will be connected at the bottom of the sensor. Either location they are easy to remove and replace.
What causes a 1993 Pontiac Grand Prix not to start There is not even a click when ignition key is turned radio and lights do come on and it has a brand new battery Previous a loss of power occurred?
I have a 2002 Grand Prix and mine does this sometimes and I have to wiggle my battery cables and it will start right up but it could also be caused by a bad ignition or fly wheel I had a 93 Grand Prix that did the same thing. Problem was caused by a tumbler in the ignition switch being out of alignment; that would not allow the starter to receive power.
Your 93 grand prix died while driving it turns over but won't restart now what can you try to do to it to fix it?
If this is the 93 Grandprix with the 3.1 eng. the Knock sensor is located just under the manifold back next to the fire wall you can see it from the bottom. It's hard to get to if you have small hands you can touch it from the bottom. However it is much easer to let the eng. cool down lean over the eng. close to the front of the eng. if you can get…
It should be directly on the outside of the Air Intake box (where your air filter is). It is a small (about 2.5-3 in long) black sensor that fits into a hole on the Air Intake box. It has two (2) female connectors that accommodate the a two-pronged plug. (there are only two wires on this year model) In later models, (like my 95 T100) the IAT sensor is built into (and part of) the…