It is located to the right of the serpentine belt, left of the intake manifold, directly above the water pump. It has two rods coming out of it and it electric controlled, not vacuum.
The temperature blend door actuator is almost straight behind the radio.See "Related Questions" below for detailed instructions on replacing the actuator.
where is the tcm in a windstar 2000 located
The EGR valve on a 2000 Ford Windstar is located on the intake manifold near the firewall. It is typically located to the left of the main throttle body or slightly lower than the throttle body. On the passenger side it is located on the side of the intake manifold closest to the firewall. On the driver side it is located on the side of the intake manifold closest to the engine.
The speed control device or speed sensor on a 1995 Ford Windstar is located on the transmission. It is a plug in just behind the bell housing.
You can not because it doesn't have one. It uses a new electrically controled by wire throttle system that has done away with the IAC and in its place uses a throttle actuator "control module" located on the intake manifold.
On idle speed control actuator is located on the front of the air intake plenum
There is only one thermostat relating to heating/cooling on the Windstar, and that's the one on the engine.If you're looking for the temperature adjusting/setting control, that's the temperature blend door and the actuator motor that drives it, based on the dashboard slide adjuster.See "Related Questions" below for more
Finding the intake manifold runner control on a Dodge Avenger is easy. It is located near the engine.
The Idle Speed Control actuator is located right behind the air intake plenum
it will be on the intake manifold.
Given that this question is posed in December (Winter), I'll assume the referenced actuator is the one that controls the temperature blend door...That actuator is almost directly behind the radio. It can be accessed easiest by removing the radio (not hard to do), and/or up from underneath down by the gas pedal.See "Related Questions" below for lots more
The radius arm is part of the front suspension - connecting from the control arm to the frame. The bushing is at the end that connects to the frame.See "Related Questions" below dealing with the Windstar control arm.