answersLogoWhite

0

  • Jeep Cherokee
  • Jeep Grand Cherokee Laredo
  • Jeep Grand Cherokee Limited

Where is the MAP sensor on a 1985 Jeep Cherokee?


Top Answer
User Avatar
Wiki User
Answered 2010-07-08 02:29:15

There is not a map sensor on an 85. They did not show up till 86 with the 2.5 fuel injected engine.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

Where is the air flow sensor for 1995 Jeep Cherokee?

There is no afs on a cherokee, they run on a map sensor.


Where is the MAF sensor on a 1998 Jeep Cherokee?

A 1998 Jeep Cherokee does not have a mass airflow sensor. It uses a manifold pressure sensor, MAP, which is on the rear of the intake manifold.


Do any one have a pic of a map sensor for a 1990 jeep Cherokee?

Below


What does it mean when the TSP does not correlate with the map sensor on a 97 jeep Cherokee V6?

The TPS is not happy with the readings from the map sensor. More than Likely you have a bad sensor.


Does a 1996 jeep grand Cherokee have a mass air flow sensor?

No, it uses a MAP sensor (manifold absolute pressure)


What is diagnostic code 14 on a 1996 jeep grand Cherokee?

Map sensor voltage low.


Where is the Intake Air Temperature sensor located on a 2000 Jeep Cherokee?

it is in the intake manifold by the throttle body and the map sensor. it is a two wire sensor


Where is the map sensor for a 1996 Jeep Grand Cherokee located?

It is located at the driver's fender side of the the throttle body.


Where is the map sensor on 1985 a silverado?

That year did not have a MAP sensor.


Where is the map sensor on a 1993 jeep grand Cherokee?

5.2 v8 is located on the front side of the trottle body just above the intake.


Where is the map sensor on a 2000 Jeep Grand Cherokee?

Which motor does it have? If it is the 4.7L V8, it is on the front of the upper intake manifold, behind and off to the left of the alternator.


What is purpose of map sensor on a 98 Jeep Grand Cherokee?

it checks to see if you are on the road or not. No, it actually tells the computer how much air is going in, allowing it to adjust the fuel air mixture. the jeep will not run very well at all without this sensor.


1990 Jeep Cherokee Sport that has no spark from the coil and I replaced both module and coil and still doesn't work What could be wrong?

Check the MAP sensor. To see if this is the problem, assuming that the Jeep won't start but is turning over, unplug the MAP sensor and then plug it back in. If you can start it now, the MAP sensor needs to be replaced. The MAP sensor is located in the engine compartment, where the firewall meets the body at the top of the engine compartment, on the driver's side. Good luck.


Where is the Map Sensor located on a 2002 Jeep Grand Cherokee Laredo?

If you have a 4.7 liter engine, the map sensor is located on the front of the intake manifold, behind the A/C compressor. Removing the upper air box may help in seeing the map sensor and also be out of your way for removal and install. Hope this helps.


What does your map sensor do on my 5.2 liter jeep grand Cherokee do?

The map sensor measures intake manifold vacuum . The signal is varied from high to low, this voltage signal change along with the throttle position sensor,vehicle speed sensor, o2 sensor, the computer uses the signals to vary injector pulse width.


What is a map sensor on a 1990 Jeep Wrangler?

You want to look on the intake manifold on the Jeep Wrangler.


Where is the maf sensor on a 2000 Jeep Wrangler?

It does not have a MAF, it uses a MAP sensor on the firewall above the intake.It does not have a MAF, it uses a MAP sensor on the firewall above the intake.


What are the ODB1 codes 12 14 15 on 1995 Jeep Grand Cherokee?

12 Battery voltage disconnected14 MAP sensor voltage too low15 No vehicle speed sensor signalAnswerSee the web site to the right.


Where and how do you install a MAP sensor on a 1997 Jeep Grand Cherokee Laredo?

The manifold absolute pressure sensor is installed in the intake manifold it is a simple installation thread in thread out.. but it is in various locations on the manifold depending on which engine you have The chilton or haynes manual will show you.


1996 Jeep Cherokee is running rich black smoke and running rough its not the Throttle Postioning Sensor or MAP sensorchanged fuel filter plugs and cap checked for vacuum leaks any suggestions?

You might look at the o2 sensor or the temperature sender


Can you clean the map sensor on the Jeep Liberty?

Yo don't. It must be replaced if faulty.


1999 Jeep Cherokee Classic 44 4.0L does not want to idle when cold does anyone have suggestions on what the problem may be?

soundsl Ike the TPS on the throttle body is bad or the MAP sensor is bad. probably tps.


What does diagnostic code P 0108 mean for a 2004 jeep Wrangler 4 cylinder?

P0108 is map sensor volts too high. The map sensor could be bad, or the wiring could be broken. The map sensor bolts to the rear of the intake on the 4cyl.


Where is the MAP sensor on a 1998 Jeep Wrangler located?

It is located on the drivers side of the throttle body


What is the 1994 jeep Cherokee 4.0l timing procedure?

the timing on all the 4.0l (242 cid) engines are set and only adjustable through the computer sensors (map sensor). It is not physically adjustable. So there is no procedure for you to adjust it.