answersLogoWhite
Chevy Lumina
Chevy S-10
Cadillac DeVille
1995-2005 Chevy Cavaliers

Where is the Map sensor located on a 1993 Chevy Lumina 3 1?

515253

Top Answer
User Avatar
Wiki User
Answered
2005-04-21 14:30:22
2005-04-21 14:30:22

The MAP Sensor is on the back side of the engine, toward the top-middle. There should be a bracket w/ a hose coming out of the center. The MAP Sensor should be just to the left of the hose (Passenger Side).

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Assuming that it is a 3.1 V6, as most of them are, there is no cam sensor. Only a crankshaft sensor. It is located behind the harmonic balancer. To replace it the balancer has to be removed.


There is no cam sensor on a 93 3.1. Just a crankshaft sensor....which is located behind the harmonic balancer. WRONG! it does in Fact have a cam position sensor! its underneath the intake plenum!


There is no cable....It's all done with a sensor and electronics.


Lumina in USA does not have a carburetor


I have a 1993 Chevy lumina van that has heat but doesn't have a fan how do I fix the fan?


on most cars it in the front at the bottom of the by the crank pully


It is located either on the manifold or somewhere on the exaust


The crank sensor is located on the rear of the engine,on the right hand side about 5 inches from the oil pan.


That year did not have a crank sensor on it.


The knock sensor for the 1993 Chevy Cavalier is located in the back of the motor. It can also be located in the engine valve.


No, Chevy Lumina Z34 ever came with a 3.7L engine. So probably not.....


how do you change the heater hoses on 1993 chey lumina 3.8 liter


How do you adjust the parking brake on a1994 Lumina?


Spark Plugs on a LuminaSee the related questions to the right. HOW DO YOU CHANGE THE SPARKS PLUGS ON A 1993 CHEVY LUMINA APV 3.8L 231-V6 ENGINE (an van)



The accumulator which is the filter for the a/c system is located on the drivers side in front............


The sensors are located on the transfercase for your cluster panel


I had to go to a dealership in order to find the location of the cam position sensor on a 1993 / 3.1 chevy lumina. I could order the part but was unable to find the location. after returning from the dealership. I am here to discredit those who say it doesn't have one. it in FACT does have one!. It is located under neath the intake plenum..


A BAD CRANK SENSOR WILL CAUSE NO SPARK AND NO PULSE SIGNAL TO FUEL INJECTORS a bad ignition module will cause no spark its located under the ignition coil trio pack


locate your fuse box it will be in their it will be round


the beretta and lumina motors are about the same i have a lumina motor in my 95 beretta


The crankshaft sensor is located on the side of the motor towards the firewall. It is located more towards the oil filter,


The fuel level sensor would be located in the fuel tank.


One reason a 1993 Chevy Lumina may turn over but not start could be the battery. It may also be the spark plugs.


The VSS sensor is the vehicle speed sensor and it is located in the transmission. The purpose of it is to operate the speedometer and abs system.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.