IN FRONT OF THE CAR LOOKING AT THE MOTOR. CHECK BELOW THE EXHAUST MANIFOLD TO THE RIGHT WHERE THE ENGINE AND TRANS BOLT TOGETHER. IT'S KIND OF HIDDEN. ALSO MAKE SURE THE MOTOR IS COOL WHEN CHANGING, IT IS PRETTY CLOSE TO THE MANIFOLD.
in the fuel tank
The carburetor on a 1998 Ford Escort with a V4 engine is located next to the valve cover. It is on top of the engine.
on valve cover just remove wires
I have a 1998 Ford Escort ZX2 and the PCV valve was located to the right of the exhaust heat shield in front of the engine block. All I had to do was pull the rubber elbow out that was connected to the PCV valve and then pull the valve out. It was arguably the easiest maintenance work I've done on a car. I didn't have to take apart the heat shield or any other component.
On the 1998 Ford Explorer Sport with 4.6L V8 the positive crankcase ventilation (PCV) will be located on the driver's side of the vehicle. On top of the front-left engine valve cover will be a grommet and hose assembly. In between the grommet and hose, and attached to the valve cover is the PCV valve.
the recharge valve is the smaller valve on the low pressure side (line). it is located above the dryer and next to the low pressure switch.the valve is on the line right next to the firewall on the passanger side.
On all cars it is located on the throttle plate. That is where the air intake and throttle linkage are located.
Same answer as the 97 escort question.
were is the egr valve located on a 1998 infiniti i30
on a 1998 Pontiac gan am ,they do not have a pcv valve.
where is egr valve on 1998 ford contour
I believe that is 4 OT.