It's on the rear valve cover. The easiest way to change it is to pull off the alternator. It's also the easiest way to change the rear spark plugs and wires.
The master cylinder contains the reservoir for the brake fluid. This is where you would add it on an 1990 Cutlass Supreme.
No, totally different bodystyles
According to http://consumerguideauto.howstuffworks.com/1990-to-1997-oldsmobile-cutlass-supreme-4.htm, the fuel capacity for the 1994 Cutlass Supreme is 16.5 gallons. Many years ago I owned a 1968 Cutlass Supreme convertible--a very fun car.
the hot wire goes to the starter and the ground wire bolts to the engine block.
the alternator is located on the upper left hand side of the engine. just follow the belt and you will find it located at the top.that is where mine is.
I have a 1990 Cutlass Calais. I had to remove a plastic panel under the steering Column. It was located to the left of the column under the dash.
junkyards, e-bay or craigslist.
Well the engine might be flooded
The firing order for a 1990 Olds cutlass supreme 3.1litre is 1, 2, 3, 4, 5, 6. The number one cylinder is closest to the pulleys on the left as you face it.
you probably have half American standard and half metric.
If it's a 1990-97 model, yes.
The firing order for a 1990 Oldsmobile Cutlass Supreme with a 3.1 liter engine is 1-2-3-4-5-6. When facing the car, the spark plugs are 2, 4, and 6 in the front and 1, 3, and 5 in the back.
I have 90 cutlass supreme. look under center of car for gas tank. should be on back end of the tank. need to jack up high enough to get at.
steering fluid reservoirunder hood, passenger side, above serpentine belt.
On the engine family .. LTK 3.0 T5 FCC1 there is no PVC valve on 1990 Mazda MPV
diagram of firing order on a 1990 Oldsmobile cutless 3.3 engine
disconnect cables from battery. follow pos. cable to starter and disconnect. follow neg. cable to end disconnect bolt mounted to engine. good luck. hamsandwich
Use a "C" Clamp to fully retract the piston into the caliper body
you will have to drop your gas tank its inside the tank drive safe
GM vehicles do not use inertia/reset switches.
I found it in my repair manual. It is about 26 to 32 psi.
where is the PVC valve located on a 1990 ford ranger 2.3 L
Which valve? Engines have many! You need to be very specific about this!
the egr valve is on the engine, usually on the top near the air filter