0
The a/c blower motor is located under the passenger side dash, removal of the glove box and lower panel is needed, not too complicated to get to.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What will cause your ac and heater to stop working it do not even blow?
Blown fuse, bad heater blower motor control switch, bad blower motor, or a bad blower motor resistor pack.
Why does the alternator drop down when air is on?
The clutch on the AC compressor is an electromagnet. It draws a fair amount of current plus the blower motor and the cooling fan on the radiator.
Do you have to remove the dash to replace the fan motor for an HVAC system?
Depends on the vehicle. Many vehicles have the blower motor accessible from under the hood. Others require a lot of stuff to be removed from the interior to get to the blower motor. If you cannot see the motor under the hood sticking out of the heater/AC box you should look at a service manual (factory, Haynes, Chilton...) to see how to do the job.
Could the blower resistor on my 1989 Dodge Dakota cause the AC not to work?
Possibly. A bad blower motor resistor would cause the blower motor to either not function or function only on one speed (usually high speed). The air conditioning system is probably set up such that if the blower isn't functioning at all, the air conditioner won't function. Otherwise the air conditioner would overheat.
Where is the blower motor relay located on a 2001 Dodge Dakota?
Assuming that the Sport is the same configuration as the Country, I can give some input. Under the hood, behind the washer fluid reservoir and a little below that is where you will find the blower motor. It is fairly easy getting the reservoir loosened, but I recall that it took some effort due to the small bolt/screw heads to remove from the blower motor. It is a good idea to have a magnetic tray nearby , a good light and plenty of time to work in that tight area. You will want to pay attention to the direction of the blades when replacing the part, there may be a certain way that it needs to go in when replaced. Good luck.
How do you change a 1994 Chevy s-10 blazer AC blower motor?
The blower motor would be located under the hood, on the firewall, close to the passenger side fender.
How do you troubleshoot a left ac blower that sporadically works on a 1994 xj6?
Probably bad brushes in the motor.
Where is the blower motor resistor pack located on a 1994 mercury villager?
On the bottom of the heater/AC housing under the dash.
What could be wrong if the AC blower on a 1995 Ford Windstar will not blow air?
fuse, wiring, blower motor, blower motor switch, blower motor resistor
What function does the blower motor have in relation to the ac system?
The blower motor circulates the air through the system.
How do you know ac blower motor bad on 1990 Toyota?
If you have checked and the blower motor has both power and ground then the motor is bad.........
Where is the rear ac blower motor resistor on a 2001 odyssey?
where is rear blower motor resistor on a 2001 odyssey
Your ac in a Chevy Corsica the blower motor goes on and off sometimes why is that?
Compressors going bad on the AC <-- NO not probable. Maybe the blower motor going our or a relay or sensor
Why does the ac fan in your 2004 Chrysler sebring only work on high?
The blower motor resistor has failed.The blower motor resistor has failed.
On a 1994 Oldsmobile regency 98 where and which one is the ac blower motor relay?
Under the hood under the plastic maxifuse center on the firewall you will see several relays there. The blower relay is the 1st or 2nd on the left hand side. The other is the ac clutch relay - feel the one that clinks with the ac and the blower is the other one.
Why Ac fan does not work on Max?
Your AC fan is not working on the maximum setting because you have a bad blower motor resistor. This is located under the dash or next to the blower motor.
How do you replace the ac blower motor on a 2002 Bonneville?
Replacing the ac blower motor on a 2002 Bonneville is extremely dangerous and unless you know what you are doing it is best to get a hired professional to do it.
