Where is the automatic transmission gears console light bulb and how do you change it on a 1991 Pontiac Firebird?
The bulb is located to the rear(back near the #1) underneath the console plate. It is a smaller bulb like a #194. You do not have to remove the shift handle. Take out the ashtray, and carefully pry up along the edges of the plate. It is held in place by tabs that fit into the console. You'll be able to lift it high enough to see the wire to the bulb connected to the underneath of the gear indicator, twist the bulb housing and pull off, take old bulb out by pulling it straight out and replace. Assembling is the reverse of the above steps.
On a 2002 Ford Taurus : You could have the gear shift lever up by the steering wheel or by the floor console for your automatic transmission And , if you mean the automatic transaxle ( transmission ) fluid level dipstick , it is near the firewall between the engine and the brake fluid reservoir in the engine compartment
Why won't a Geo Tracker Automatic transmission shift from park with the linkage from the transmission?
How do you remove the center console on a 1992 Subaru Legacy with automatic transmission to replace the parking hand brake assembly?
Several variables here. Automatic or manual. Linkage on transmission or at shifter in cabin. Automatic shifter uses a cable, and can be accessed in cabin by removing the screws around the shifter, no need to take the console out. Once the plate is off you will see a single bolt through an 'eye'. At Transmission another single bolt holds a lever on. Manual uses a combination of a cable and steel rods. In cabin, remove…
Under what circumstances is the Administrator password not required when launching the Recovery Console?
If "Recovery Console: Allow automatic administrative logon" is enabled. If "Recovery Console: Allow automatic administrative logon" is enabled. Also, if the registry is corrupted to the point that it cannot read the password, you are not asked to provide one, and are limited to what you can do in Recovery Console.
2000 Honda accord automatic transmission-will not come out of park without manually engaging the detent in the console you have replaced the solenoid in the console didn't help?
To change the shift linkage in an 1998 automatic Chevy Cavalier the shift linkage needs to be removed from the transmission and pulled from the cabin. The job requires removing the floor console to access the cable. After doing the so the cable can be snaked from inside the cabin, the install is the reverse of the removal.
Depending on the year the car was built. For the 2007-2008 USDM Honda Fits (GD3), there is a Honda OEM center console with an armrest built in which was only made for the Japanese Fits. These can generally be bought for around $300 and install relatively easily. If you have the 2009 USDM Honda Fit (GE8), then Honda offers a center console with an armrest for Fits equipped with the automatic transmission only. I'm not…
What does the small button located at the bottom of the automatic transmission housing do on a 1991 Geo Tracker?
Two automatic transmissions were available in 1986. Three speed automatic (says PRND21 on shift indicator on dash on console) is a Turbo Hydramatic 125C (TH125C). Later models it was called the 3T40. Four speed automatic (says PRN@D21 on shift indicator, and says "AUTOMATIC OVERDRIVE" in tinier letters over that) is a Turbo-Hydramatic 440-T4. Later models had the 4T60 which is a different transmission entirely.
Can you convert a manual transmission to an automatic in a 1995 Acura Integra and if you can what changes need to be made?
Yes, it is possible to convert a manual into an automatic. I converted my automatic integra into a manual. It runs smooth as silk. To tell you the truth and not to discurage you, it would be easier to sell your manual or even trade it for somebodys automatic. There are many Integra lovers that would love to get their hands on a manual. If this is not possible here it goes. It will be…
Where is the automatic transmission gears console light bulb and how do you change it on a 1999 Pontiac firebird?
It is located under the center console lid. To change put the key forward, not starting the vehicle and slide the gear select in the lowest possible gear. This should be 1 on an auto, some older models equiped with 2.73 gear sets have consoles begining in 2. After the gear select is in the lowest setting, you will see a U shaped clip holding the T handle shifter. Use a flat blade screw driver…
C-4 and duct tape. But seriously, it is a design flaw in the machine. I've gone through four (4) cables in the past year because top of the line replacement parts are BS! Barring redesigning the system yourself; stock up them cables, reschedule all of your Saturdays and get use to not having a center console.
Open the console lid. Remove the console compartment inserts. Remove the transmission select switch (if equipped). Remove the nuts that retain the rear of the console. Remove the cup holder insert. Remove the screws that retain the front of the console to the vehicle. Remove the console from the vehicle
you fill your transmission with gear oil as opposed to transmission fluid for automatic transmissions. you fill your transmission by removing the plate around the shifter from inside the cockpit of the car. pop out the plastic console around the shifter, remove the shift boot (leather/fabric) then you will see the top of the transmission. there is a plate with 6-8 nuts that you remove, pop the plate off, and pour in the gear oil…