on the trans
where do you install a neutral safety switch on a 1996 saturn
look down on the tranny itself.
its the safety neutral switch
The combination neutral start and backup light switch is mounted inside the shifter housing. Remove the screws holding down the shifter housing and remove the switch. Adjust the switch by moving it on its mounts.
It does not have one.
switch is located on front of tranny,look for plug with 3 wires.i just fixed mine and had to remove battery and tray to access part.good luck
ON my 1996 Dodge 2500 it is on the drivers side. On the transmission housing just above the pan gasket and around where the linkages all intertwine an connect to the housing.
Look under the dash on the 1996 suburban, and locate the brake light switch on the brake pedal arm. Remove the switch nut, and slide the switch out. Unplug the wires from the switch and install the new switch.
the two top ones.
where is the brake light switch for 1996 Oldsmobile cutlas supreme
The break light switch is located on the backside of the break peddle arm.
No Backup was created in 1996.
Drivers side between the fuse box and strut tower.
There are several relay switch is on your 1996 GMC Jimmy. The brake light relay switch can be found below the dashboard in the engine compartment.
on your dash,
the reverse light switch is usually mounted on the shifter inside the car.
NOT AT ALL
The 1996 GMC Yukon brake lights work by receiving power from the brake light relay switch. The brake light relay switch is connected to the brake pedal.
On the turn signal indicator arm. Switch on the headlights, make sure the high beam is off, then pull out the rotating light switch.
The blower resistor is under the dash pad on the top of the heater box
A 1996 Saturn vehicle will only use R134A refrigerant. I was a Saturn technician for years in Saturn Dealerships.
On the top of the transmission.
Selling price of a 1996 Saturn?
timing for spark plug wires for saturn sl1 1996