answersLogoWhite

0


Best Answer

If this is in reference to heater fan speed control, it is typically mounted inside, on the firewall, on the passenger side, under the glove box.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the ballast resistor on 1984 ram van?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does a 1997 Dodge van 1500 have a ballast resistor?

No.


Where is the ballast resistor located on a 1989 350 Dodge Van?

Usually against the firewall in the center It most liley does not have a ballast resistor.


Where is the blower motor resistor switch on the 1984 Dodge Ram Van B350 and how do you replace it?

It is on the Right side of the Heater Core Covering.


Why would a 1984 dodge ram camper van 5.9 v8 cylinder run fine til a new alternator was put in Engine will start well key is in start position but die when key flips to the run position.?

Ballast resistor? Distributor pick up plate? I put in a new resistor and pulled one of the plugs it has spark


Where is the ballast resistor located on a 1985 Dodge V8 Prospector van?

Usually against the firewall in the center section


What are the symptoms of a heater blower resistor gone bad in a 2000 dodge ram van?

Blower fan inoperative or only works on high speed.


What transmission is in a 1984 B 150 dodge ram van with a 3.7 L 225ci engine?

904 is the transmission


How do you install timing belt on 1996 dodge ram van?

A Ram Van does not have a timing belt.A Ram Van does not have a timing belt.


Why does the blower fan on a 1999 Dodge Ram Van only work on high?

Most likely the blower resistor has failed. It is located under the hood in the side of the heater box.


What is the 1997 fifteen passenger ram van called?

A Dodge Ram Van.


When was Dodge Ram Van created?

Dodge Ram Van was created in 1971.


Why does your 1977 Dodge 318 van not start?

You need to determine if the problem is fire or fuel. On the firewall the is a white ceramic ballast resistor that is bad about burning out. It controls the fire to the distributor. If you are not getting fuel, then you need to check the fuel pump for pressure and volume.