0
Where is the bleed screw located for the clutch on an SC2 coupe?
Wiki User
∙ 12y ago
From what I have heard you cannot bleed the clutch in a Saturn because it is all one peice. this was form a Saturn mechanic. hope it helps.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you bleed the clutch on a 2000 Toyota Tacoma 4x4?
the best way to "bleed" any clutch is to get a can with a pump and a hose that will fit over the bleed screw. Loosen the bleed screw put the hose over it and pump fluid back up to the master cylinder this will force any air out.
How do you bleed a f250 hydraulic clutch?
you bleed it just like you would blled your brakes 2 people one pumps then hold clutch the other opens bleed screw on slave cylinder till you get stream of fluid no air about 2 times then refill master cylinder but there is no bleeder screw on clutch
How do you bleed a clutch on a 1993 Honda Civic?
Pump the pedal to the floor and then screw on the cylinder.
How do you bleed the master clutch cylinder on a 95 fire-bird?
Fill resevoir Open bleeder screw to let fluid run out depress clutch pedal to floor Close bleeder screw
How do you bleed a clutch in a 1990 Chevy truck 350?
there are two places to blead your clutch and its a two person job the first thing you do is fill the clutch master cly. theres a bleeder screw on it then refill the cly. and bleed it at the slave cly. this is all done the same way you bleed your brake system
How do you bleed the slave cylinder on a 1993 Jeep Wrangler?
Right above the slave cylinder there is a bleeder screw. Just unsrew it and have someone hold in the clutch to start the bleed.
Bleed clutch on ford transit van?
A person can bleed the clutch on a Ford Transit Van by hooking a bleeder hose to the slave cylinder, placing it into a small jar of hydraulic fluid, and loosing the bleeder screw. The clutch is then slow pressed until no air bubbles are present.
How do you bleed a clutch for a 1995 Chevy Cavalier?
fill the clutch resivoir pump the clutch pedal open the bleeder screw and tighten it back up and repeat until the air is out and just fluid comes out
How do you bleed the clutch on 1997 Pontiac Grand Am?
Loosen the bleed screw next to the entry point on the transmission, open the clutch master cylinder (drivers' side rear corner of the engine bay), and let it bleed. It's helpful to use a hose over the bleed screw that goes into a bottle so you can watch for bubbles. Keep an eye on the fluid level as it should drop fast. Don't pump the clutch or hold it down. The bleeding is supposed to just happen with gravity. Good luck
Bleed clutch cylinder on a 1991 Nissan 240sx still no presure on the padel?
You must bleed the clutch dampener before bleeding the slave cylinder its that weird curvey steel hose before the slave unter the passangers feet. look arount the side of the dampner for the bleed screw
How do you bleed the clutch line on a 2004 Ford F-250 with no bleed screw on either cylinder?
There wont be one on the master but there is one on the slave, it looks like a grease fitting.
Where is the bleeder screw for the clutch located on a 1996 Chevy cavalier?
I'm having a hard time finding the bleeder screw for my clutch on a 96 Chevy Cavalier 2.2? Can you help?
