like before all resistors fof heating are on duct work of blower motor either under dash or on clow mounted to firewall.to replace buy one at dealer ship or ask to look at one. only two screw mount
But what makes you think it's the resistor. It could be the switch . It probably came apart and all you have to do is put the 2 parts back together.
The blower motor resistor on a Mercedes 300e is located beneath the blower motor on the Mercedes 300e, if ever it needs replacing.
If it looks the same as the European Sunny the resistor is located on the (right hand drive) passanger side. Under the dashboard (or under the glove box) the blower is located. The resistor is located in the blower housing (so the heat is blown away). The resistor is connected by a 4 pin long connector. Pull this one out and unscrew the 2 screws that are located near the 4pin. Then you can get the whole (creditcard) resistor out. Replacing the resistor in Holland costs about 60 euros, but in the us the come around $15.
where is the temp sensor on a 2007 ford fusion 4 cylinder located
The blower fan resistor is located in the foot well of the passenger seat (under the glove box). Remove the two screws and pull the resistor down and out. Unplug the resistor and look at the metal contact points. If they are burnt out you might have to replace the plug and resistor. Replacing the plug requires light electrical work involving crimping/splicing wires.
The blower fan resistor is located in the foot well of the passenger seat (under the glove box). Remove the two screws and pull the resistor down and out. Unplug the resistor and look at the metal contact points. If they are burnt out you might have to replace the plug and resistor. Replacing the plug requires light electrical work involving crimping/splicing wires.
The ballast resistor is located on the left inner fender.
it in your gas tank access from rear hatchback area under right cover plate drive safe
The blower might need replacing. Normal cause is a failed blower resistor, caused by a blower fan that is failing.The resistor and fan are located above the passenger side floor behind the glove box.
The blower motor fan cools the resistor so the resistor is usually located close to the blower.
On my 1998, the slave cylinder is located inside the bell housing - a very stupid place for it IMO. If you are replacing the slave cylinder, it might be a good time to replace the clutch too.
The blower resistor is located over the passenger side strut tower.
The ballast resistor is located either on the firewall or on the left inner fender.