under dash on passenger side in ductwork'
Check to see if you have 12 volts at the blower motor. If yes then the blower motor is bad. If no, then the resistor, relay, or fuse is bad.
You either have a blown fuse, defective blower motor, defective blower motor switch, or a defective blower motor resistor pack.
They are generally located close to or near by the blower motor.
Could be, a blown fuse, a bad blower motor, a burned out blower motor speed resistor, a bad blower motor switch,
under glove box passenger side
If you have only high speed on the blower motor or you are missing one or more low speeds, chances are the blower motor speed resistor is burned out.
It is usually under the dash on the passenger side right next to the blower motor. On some, it is mounted on the same bracket as the blower motor.
The blower motor resistor is located on the right hand side of air inlet(plenum). Where is the air inlet? Where is the (plenum)?
It is usually a resistor on or near the switch in the dash.
Could be,Blown fuse,Bad blower motor,Bad blower motor switch,Bad blower motor speed resistor,
the blower motor resistor should be behind the glove box. just unscrew the two screws and that should be it.
Look on the top of the blower motor under dash passenger side near glove box area
Resistor on the heater blower motor has failed
Adjacent to the blower motor, behind glovebox compartment. Has 4 pin connector going into it, mounts into air passage for cooling.
open your glovebox, release the hydraulic arm from the right side of the glovebox. Next, lower the glovebox by pulling in left side. In front of you is the blower motor. To the left of the blower motor is a set of wires that are plugged into the Resistor. Unplug and unscrew to remove Resistor.
Blown fuse? Bad blower motor? Bad resistor pack at blower motor? Bad switch?
There is none - usually it is the module in the top of the heater / blower box (resistor module) that is the problem.
On the bottom of the heater/AC housing under the dash.
It's right at the bottom of the blower motor behind the globe box...
Remove and test with an ohmmeter Explain how to test with an ohmmeter?
if it doesnt work on 1 and 2 it could be a blower motor resistor but if it doesnt work at all check the fuses, relay and check voltage if it reads 12 v replace the motor
how to install a blower motor for a 1994 Toyota pickup
Start by checking the fuse. If the fuse is good, apply 12 volts directly to the blower motor. If the motor runs it is good. Check all the wiring for loose or burnt wires. If all this checks out, then the Blower Motor Resistor Pack may be defective, or the blower motor speed switch itself.Start by checking the fuse. If the fuse is good, apply 12 volts directly to the blower motor. If the motor runs it is good. Check all the wiring for loose or burnt wires. If all this checks out, then the Blower Motor Resistor Pack may be defective, or the blower motor speed switch itself.
How do you replace the blower motor on a 1994 chevy lumina euro?