Open the glove box and it is located right behind it. two bolts and it comes right out.
The blower motor resistor is over the passenger side strut tower, under the hood.
The blower resistor is behind the glove box. It mounts to the HVAC housing.
The blower motor resistor has failed.The blower motor resistor has failed.
It is behind the glove box.
Check the blower motor resistor
On an auto temp system the blower motor resistor has failed and needs replaced.
Blower motor resistors are usually located close to the blower motor.
Fig 15 Blower Motor ResistorNOTE: The blower motor resistor is located on the lower right side of the heater housing.REMOVAL# Remove lower right underpanel silencer/duct. # Disconnect wiring connectors on blower motor resistor. # Remove blower motor resistor retaining screws. # Pull blower motor resistor out of heater housing.
Resistor or blower motor power module.
The blower motor resistor is mounted behind the glove box door.
When the fan is on high it does not run through the blower motor resistor. The low speeds don't work because the blower motor resistor is bad.
The blower motor resistor location on a Chrysler 300M is on the passenger side of the vehicle. It is on the floorboard next to the inside firewall, just in front of where the passenger sits.
When that happens on a Chrysler Town and Country with auto temperature, the blower motor power module has failed. It is also called a blower motor resistor.
The blower resistor is probably bad, due to a failing blower motor that is drawing too many amps.
under the dash. if you can find the blower motor then it should be right above that
The blower resistor is under the hood, over the passenger side strut tower. You will need to look way up under the wiper cowl.
The most likely problem is the blower resistor located behind the glove box door.
A malfunctioning blower motor resistor will cause the blower motor not to work. When the resistor is bad the blower motors will not turn on.
blower motor resistor needs to be replaced
It is under the dash on the passenger side.
blower motor resistor
usually by the blower motor -- look behind glove box area or under hood near blower motor
On the auto temp system that happens when the blower motor resistor fails. It is behind the glove box.
The usual cause is a failed blower motor resistor.
The a/c heater blower motor resister is located in the vehicle on the passengers side inside the housing next to the blower motor...............Remove the blower motor resistor wire harness connector.Remove the blower motor resistor screws.Remove the blower motor resistor.