Raise your hood. Look at Right Hand back firewall. (Passenger side)
You can see the rear of blower motor.
Look beside it there is a plug (I believe to the bottom right)
The small rectangle assembly under that plug is your resistor block.
Remove the 2 bolts that hold it to the firewall and pull it out.
Reverse procedure to reinstall.
Then you will be cooking -w- heat again
Resistor is located behind the blower motor assembly.
where is the location for a blower motor relay on a 2006 ford freestar
The blower resistor controls the speeds of the blower motor Hi-resistance lower motor speed Lo-resistance higher motor speed
# Locate the blower resistor under the right-side of the instrument panel # Disconnect the electrical connector from the blower motor resistor # Remove the blower motor resistor mounting screws and remove the resistor from the housing # Installation is the reverse of removal
They generally locate the heater motor speed resistor nearby the blower motor because the resistor depends on the blower to keep it cooled.
Blown Fuse, loose or disconnected wire, or defective blower motor resistor pack.
The heater resistor coil is located on the blower motor on the 2006 T300 Kenworth.
blower motor resistor needs to be replaced
blower motor resistor
Could be, blown fuse, bad blower motor, bad blower motor speed resistor, bad blower motor switch,
The blower motor speed resistor is burned out.
more than likely will be the blower motor resistor has went out.