How do you replace the heater blower motor resistor on a 1998 gmc serria 1500 p/u
Depends on what you mean by heater will not work. If the blower motor will not work, it can be a blown fuse, bad blower motor, bad blower motor switch, or a defective blower motor resistor pack. If you mean that the blower motor works but there is no heat, then it can be a clogged heater core, thermostat stuck open, or defective heater control valve.
I need to know how to replace a heater core in a 1992 GMC Jimmy?
Remove blower motor 97 GMC jimmy
heater control valve located on 2001 gmc jimmy 4.3l
The A/C - Heater blower motor will be located on the passengers side behind the glovebox and you will have to loosen the dash on that side and pry it up very carefully.......
It can also be a blown fuse, or a defective blower motor resistor pack.
where is the oil pump on a 1998 gmc jimmy in the oil pan.
heater core is behing the dash on the passengers side and the blower more same side but under the hood up against the fire wall. Its round you cant miss it.
ok primero se asen cola y luego blanbla
A diagram of the heater core of a 2001 GMC Jimmy can be found in the service manual. It outlines the location of all the components and how they are connected.
Better check your title. Jeep doesn't make the"Jimmy". Jimmy is made by GMC, The blower control module on a GMC Jimmy is located in the heater unit which is a plastic housing located on the left (passenger) side of the firewall. However, Jimmys are noted for bad connections on the module plug , the motor plug, & some have another plug that goes bad regularly to the rear of the left fender well. You would be wise to check those connections before buying parts. Good luck.
gmc jimmy rear reservoir location
Under the hood , in the main fuse box. It should be a relay in the main fuse box , that is located under the hood.
BLOWER MOTOR RESITAR SWITCH
per vehicle specs on a 1998 gmc jimmy 4x4, the correct size tires are 235/70/15
The air door actuator on a 1998 GMC Jimmy is located in the dash. It is located behind the glove box.
below glove box remove heater/air conditioning cover then remove blower motor cover
It is 5x4.75
There are 2 of them.
location of the O2 sensor heater on a 1998 GMC 5.7
my 1998 gmc jimmy has no floor heat but i have defrost and ven heat
The easiest and quickest way to change the heater core in your 1988 GMC Jimmy is to remove the water from the cooling system. Remove the water lines from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.