The blower resister is located under the dash in the passanger footwell. You will have to remove the shroud that extends along the underside of the dash. You will see the blower motor and the wiring harness, the resistor is in front of the blower. Just disconnect the harness from the resistor and two screws and the resistor should drop out. If the resistor is original eqipment the replacement from GM is slightly different. You don't need the plastic retaining part when you put the new one in. Expect some problems putting the shroud back in place... Hope that helps..
I had no high blower and after checking harness with a multimeter had over 14 volts at the plug. Resistor/relay faulty. It is held with two 7/32" head screws and had to unplug two harnesses (carefully with small screw driver, the harnesses are held in with clips that are part of the plug). At my napa store there was two types of resistors, I removed old one first to match. Reverse procedure to install.
Replace shoes brake 2003 Chevy
I think the blower motor relay is internal to the blower motor resistor which is located under the passenger side dash.
Its not the relay, it is the blower motor resistor.
How do you replace a fan blower resistor on a vauxal Corsa?
the blower motor resistor is located behind the blower motor which is located behind the glove box there is clip wires you need to disconnect and then connect the new one.
the heater blower resistor is located on the passenger side footwell near the firewall. a complete how-to replace the resistor, along with photos is available on newcougar.org http://www.newcougar.org/forums/how-tos/3732-fixing-heater-blower-resistor-install-photos.html
The blower motor fan cools the resistor so the resistor is usually located close to the blower.
Bad blower resistor?
The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it. The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it.
You need to replace the blower motor resistor located near the glove box.
The blower resistor is located under the dash, near the floor, on the passenger side of the vehicle. I had to replace the resistor about a year ago. It is not an easy place to work in. You have to remove the blower unit in order to get at the resistor. Not fun, but rewarding when you actually do it yourself.
this resistor is located next to the blower motor in the heater plenum. the coils sit in the air stream. remove the connector and the fasteners and pull the resistor block out.