The brake light failure sensor is located at the back of the left rear lamp assembly behind the trunk liner. It is a square circuit board about 2" x 2" connected by a wire pigtail to the main left rear brake and running lights.
In the rear tail light assembly one for each side.
The brake light failure sensor on a 1997 Acura 2.2 cl is located on the rear of the car. It is on the back of the left rear lamp assembly.
These cars had issues with the pedal pressure sensor located in the brake booster. Additionally the brake booster it self is also known for failure on this car.
The brakelight sensor is located on the brake switch, which is on top of the brake pedal and held on with a 14mm jam nut.
Possible abs sensor failure.
the sensor is in the brake pad itself, it clips in top of brake pad
the brake sensor for the 2001 dodge stratus is located on the inside of the car under the brake paddle.
There is a brake fluid sensor located in the reservoir at the master cylinder. When the brake fluid is low it will turn the light on.
Mounted on the upper part of the brake pedal.
All brake light sensors are switches connected to the brake pedal. its a switch that is mounted on the front of the pedal on the top.
The sensor for the rear wheels are located on the brake shoe backing plate if you have drum brakes on the rear. The front brake sensor is located next to the caliper. The same if you have rear disc brakes.
it's attached to the r/s tail light assy.