0
What else can I help you with?
Where is the brake light switch on a 1987 mercury grand marquis?
The brake light switch is under the dash hooked to the brake pedal at about midway up. It is a little switch that is like a push button that goes "CLICK" when activated, sending a pulse to the lights telling them when to turn on and off.
Where is the ac low pressure switch on a 1987 Pontiac grand am?
On a 1987 Pontiac Grand Am, the AC low pressure switch is typically located on the accumulator/drier, which is found in the engine compartment near the firewall on the passenger side. The switch is usually mounted on the side of the accumulator and is connected to the AC system's low-pressure line. You may need to consult the vehicle's service manual for a detailed diagram or further assistance.
1987 Pontiac Grand Am?
That is not a question, but rather a statement.
Is there an inertia switch for the fuel pump on a 1987 Pontiac Trans Am?
no there is no inertia switch. gmjim
Where is the crankshaft sensor located on a 1996 Pontiac grand am with 2.4 motor?
were is the crankshaft sensor located on a 1987 Pontiac Grand AM with a 2.5L engine
How do you tighten the steering column on a 1987 Pontiac Grand AM?
Take it to the shop:)
What is the difference between the 1986 Pontiac trans am and 1986 Pontiac Grand Theft Auto?
Nothing, the GTA didn't come out until 1987.
What is ignition coil firing order on a 1987 Pontiac Grand Am 3.0 V-6?
The firing order on a 1987 Pontiac Grand Am 3.0 V-6 is 1, 6, 5, 4, 3, 2. The number one cylinder is on the front left as you face it.
What would cause the taillights on an 1987 Nissan Pickup not to work?
check your fuse and your brake light switch on your brake pedal lever.
Did Pontiac make a Trans Am Grand Theft Auto in 1985?
The Trans Am GTA was not intruduced until 1987.
Where is the brake light fuse on a 87 Thunderbird?
The brake light fuse on a 1987 Thunderbird is located on the back of the headlight switch. It is not in the fuse box.
Where is the brake light switch located on a 1987 ford thunderbird?
Under the brake pedal. Looking up at the pedal you will see the switch it is srewed to the dash and rests on the metal arm of the pedal when you press the brake pedal the switch close's and the brake lights come on. To replace the switch it is very straight forward just remove the srew from the dash separate the wire and replace..
