0
Where is the camshaft position sensor on the Daewoo Nubira CDX d tec 2.0l engine and where can you find a diagram or instructions to replace it?
Wiki User
∙ 12y ago
I have a 2001 Nubira, and the camshaft sensor was one of many things I have had to replace, if you have any problems with your steering it's probably your control arms and bushings. Now the sensor is located behind your drive belt that is connected to your alternator. In the interior area of this belt you'll see a couple of bolts which cover this sensor. You have to loosen these and I believe there is a belt cover which you must unclip in the area above the sensor cover. At this point you will not be able to get to the sensor. You must unbolt the two bolts on this that hold your engine. Don't worry the weight of the engine will keep itself in place. Now place a hydraulic jack under the engine, with a piece of wood on the part that is to make contact with the engine. Jack the engine up so that the tension is released in the area where you are to remove the sensor. You'll need a pair of needle nosed pliers to remove it, and don't forget which way it will go back in(which way was it taken out?)
Jamir Kovacek
Add your answer:
Earn +20 pts
How do you replace replace the camshaft position sensor?
In order to replace the camshaft position sensor, you would need to disconnect the electrical plug holding it in. Using a socket, hold down the bolt and remove the camshaft position sensor.
How do you replace the camshaft position sensor on a 1997 Plymouth voyager 3 L?
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
Where is the camshaft position sensor located on a 1999 Oldsmobile Intrigue and how do you replace it?
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue
How do you replace a camshaft position sensor on a 2000 Nissan Xterra?
How do u replace the camshaft sensor for a 2000 Nissan xterra 3.3L and where is its locatoin
P1345 crankshaft position camshaft position correlation?
Replace the crankshaft and camshaft senors and then clear the codes with an oBD II engine scanner and that will fix it.
If you replaced the camshaft position sensor should you replace the crankshaft position?
I changed only the camshaft position sensor on my 2000 Kia Sportage. So I don't think so.
How to replace camshaft position sensor for vw jetta 1999?
how to remplace position of oxigen sensor
Where is the camshaft position sensor on a 2006 Kia Sorento?
do you need to take off the timing belt to replace a camshaft position sensor on a 2006 kia sorento
VW Beetle 2.0 camshaft senors 2001?
Show me how to replace the camshaft position sensor on a 2000 volkswagen new beetle
How do you replace camshaft position sensor on a 2006 Nissan xterra 4.0 v6?
camshaft location on a 06 xterra bank 2
How do you replace the camshaft positioning sensor ml27 cdi?
the camshaft position sensor is on the left side of the engine , at back on the upper side . you have to demont the conector , than unscrew and replace it
Where is the camshaft position sensor on a 1996 Nissan Sentra?
in the distributor, you have to replace the whole unit.
