Want this question answered?
On a 1992 Acura Vigor idle is adjusted through a idle control valve. Tightening the valve well raise the lower the idle and loosening it will raise it.
It is located on the top of the valve cover towards the rear of the engine.
The clutch cylinder on a 1994 Acura Integra is bled by placing a tubing on the slave cylinder bleeder valve and placing the other end underneath brake fluid. Pump the clutch pedal several times and hold it down. Release the bleeder valve. Keep doing this process until bubbles no longer exit.
On the clutch slave cylinder
To bleed a clutch on a Nissan Stanza, you need to find the bleed-off valve, usually somewhere near the slave cylinder.
shhould be da same way u bleed your break system... bleed valve on clutch master cylinder...
The clutch can't be adjusted. It is an hydraulic clutch. The clutch pedal sends pressure from the master cylinder to the slave cylinder on the clutch. IF you are having trouble with it the thing to do is bleed the air out at the slave cylinder. Have an assistant pump the clutch and hold it to the floor. Then open the bleed valve on the slave cylinder to let the air out of the system. On the final bleed hold the clutch to the floor and close the bleed valve on the slave cylinder. The clutch master cylinder operates of the brake fluid reservoir. Make sure you keep this full of brake fluid as you bleed the clutch.
same way you bleed the brakes. push clutch all the way to the floor and release the bleed valve on the transmission. tighten it up, release the clutch. Need 2 people to do it.
Just bleed at the slave cylinder. It so easy, it takes 5 or 6 pumps but does need two people. One on the clutch pedal and one on the bleed valve. The person on the clutch pedal pumps a few time whilst you have the bleed valve open. Ask them to push the pedal to floor and hold. Close the bleed valve and then ask them to release their foot of the pedal. Open the valve and ask them to repeat the procedure again When pure fluid comes out make sure their foot is hard down and close off the bleed valve. Full clutch pressure will now be available. Cheers Jim from Oz
On the opposite side of the trans from where the clutch line enters, a fitting with a bleed valve on the end. You can get a great view if you remove the access panel around the shifter, you will be able to see them both from there, loosen the end to bleed.
there is a bleeder valve on the right side of the tranny that is where you can bleed your system
yes, u need to use the bleeder valve or u can gravity bleed it