On the opposite side of the trans from where the clutch line enters, a fitting with a bleed valve on the end.
You can get a great view if you remove the access panel around the shifter, you will be able to see them both from there, loosen the end to bleed.
fd
on the drivers side underneath of your jeep u will find a hose with a bleed fitting on the end by by pushing in the clutch build pressure and have a friend loosen the bleed valve to release pressure until u do not get air out when first opening the valve be sure to keep the reservior full during this process and top off after finishing if this doesnt work u most likely have a bad slave cylinder. Where is the clutch bleed valve located
Bench bleed it to avoid introducing air into the system.
How to change a clutch and master cylinder on a 93 jeep wrangler
I HAD THE SAME PROBLEM WITH MY 92 WRANGLER.. GO TO AUTOZONE.COM AND CLICK ON SERVICE MANUALS, THEY WILL EXPLAIN HOW TO BLEED THE SLAVE CYLINDER.. AND IT WORKS.. DON DRC@EPIX.NET
How do you replace the clutch slave cylinder on a 1989 jeep wrangler
Right above the slave cylinder there is a bleeder screw. Just unsrew it and have someone hold in the clutch to start the bleed.
A 2002 Wrangler has a non adjustable hydraulic clutch.
The clutch is not adjustable.
No.
No.
A 1998 Jeep Wrangler does not have EGR.